delight 39684 Double LCD Monitor Arm Instruction Manual
- June 13, 2024
- delight
Table of Contents
delight 39684 Double LCD Monitor Arm
WARNINGS!
- Before assembly, make sure that all accessories and components are available!
- During assembly, use the supplied screws, do not replace them with others! Make sure to tighten the screws with the correct torque, do not overtighten the screws!
- Keep away from children! Danger of suffocation! Small parts that can be swallowed can cause suffocation!
- The console is only suitable for indoor use. Outdoor use of the product can lead to malfunction and personal injury!
- Never use the console with a monitor heavier than the maximum weight, as overloading will cause instability, which may result in personal injury and property damage.
- The bracket must be fixed as described in the assembly instructions. Improper installation can cause personal injury and property damage. If you are unsure when installing the console, ask for professional help.
- After mounting the monitor, always make sure that the bracket can support the monitor with all accessories and cables.
IMPORTANT NOTE!
-
Make sure that all parts are included in the box before installation.
-
If any parts are missing, contact your distributor.
TECHNICAL DETAILS -
Can be used to hold 15 – 30” size televisions or monitors.
-
Maximum load capacity: Max. 9 kg / arm
-
Maximum tilting angle: (90˚)
INSTALLATION
| M6x8 screw
---|---
| M6x10 screw
| M5x10 screw
| M4x10 screw
| flat washer
| 4 mm
| 5 mm
EN : There are two ways to mount the console to the tabletop:
(1A-1, 1A-2A, 1A-2B, 1A-3)
EN : Clamped to the table top with the included mounting base.
(1B-1, 1B-2, 1B-3)
EN : Drilled through in the desired place, fixing the arms to the
tabletop
EN : Place the arm on the bracket previously attached to the tabletop, then tighten the screw.
EN : If you have properly attached the console to the tabletop as shown in the figures, connect the monitor to the arm using the VESA plate. Place a washer between the monitor and the board, then screw in the upper two screws first, then the lower two. Avoid over-tightening the screws, otherwise the monitor may be damaged. For screwing, use the included driver Allen key.
EN : Reducing the hardness of the gas spring : If the monitor rises too high, the weight of the monitor is small for the tension of the gas spring. Push the arm down to adjust the gas spring strength in a horizontal position. Then adjust the pressure of the gas spring with the help of the allen key and the screw located at the pivot point of the arm. Rotating clockwise can reduce the pressure of the gas spring. Lower it until it can hold the monitor horizontally.
EN : Increasing the hardness of the gas spring : If the monitor drops low and the bracket does not hold the monitor, the weight of the monitor is too much for the tension of the gas spring. Raise the lever to adjust the gas spring force to a horizontal position. Then adjust the pressure of the gas spring with the help of the allen key and the screw located at the pivot point of the arm. Rotating counter clockwise can increase the pressure of the gas spring. Do this until the arm holds the monitor.
EN : Display angle : If you feel that the angle of the monitor is not correct and the display is hanging down, adjust the display to the correct position and tighten the screw.
EN : Cable management : Fasten the cable guide as shown in the picture.
EN : Maintenance, condition preservation : We recommend that you check the condition of the screws at regular intervals, make sure that the product is safe to use, and if necessary tighten the screws again with the correct torque.
Customer Support