delight smart KINETIC 2 in 1 Wireless Doorbell and Night Light User Manual

June 12, 2024
delight smart

KINETIC 2 in 1 Wireless Doorbell and Night Light
User Manual
Product Code:
55346/55347

Indoor unit parts:

  1. LED indicator light
  2. Night direction light
  3. Notification mode select button
  4. Ringtone volume select button
  5. Light sensor
  6. Ringtone select button
  7. Night direction light buttondelight smart KINETIC 2 in 1 Wireless Doorbell and Night Light - Description Outdoor unit parts:
  8. Button
  9. Name plate
  10. Support bracketdelight smart KINETIC 2 in 1 Wireless Doorbell and Night Light - parts

Pairing: Connect the indoor unit to the power outlet according to the specification. The button of the outdoor unit must be paired by pressing the outdoor unit within 120 seconds after the ringing sound. You will hear a sound signal if the pairing is successful.

Setting notification modes:

Press the button, if you want to change mode. Each time the button is pressed, the device switches modes as shown below:

  1. Sound signal mode
  2. Blue light signal mode
  3. Blue light signal and sound signal mode

After selecting the last operating mode, the first operating mode follows again.
Ringtone setting: Thanks to the wide selection, everyone can find the ringtone that suits them. You only need to push the button. Wih each button press, you can move though the ringtones step-by-step. After selecting the last ringtone, the first ringtone follows again. In the case of units with several outdoor buttons, it is possible to set the bell tone for only one button, thereby distinguishing which outdoor bell was pressed.
Ringtone volume setting: 4 volume levels can be set. By pressing the button, you can lower the volume. Pressing the button after the quietest setting will return to the loudest setting option.
Setting the night direction light: Thanks to the light sensor on the top, it automatically turns on when it gets dark and off at sunrise. To turn on the function, press the button. If you do not want the device to turn on automatically at night, please press this button again.

INSTALLATION

There are two ways to fix the outdoor unit.

  1. Self-adhesive tape: The package includes double-sided self-adhesive tape, with which you can easily install the bell on most surfaces without the use of tools. Please clean and degrease the surface before fixing. With the double-sided foam adhesive, the appropriate adhesive strength can only be achieved on an even, smooth surface. Peel off the carrier film from one side of the self-adhesive adhesive and stick it to the place on the back of the bell.Remove the protective film from the other side as well, then stick the bell in the desired place.
  2. By screw: Screw the bracket to the desired location according to the marking. Peel off the carrier film from one side of the self-adhesive tape and stick it to the place on the back of the bell. Peel off the carrier film from the other side and stick the bell on the console.

Factory reset/Delete settings: Press and hold the button, until you hear a sound signal. (~20 sec)

SWITCH UNIT: IP54
DOORBELL UNIT: IP20

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals