TELTONIKA FMM125 Terminal Tracker Instruction Manual
- June 4, 2024
- teltonika
Table of Contents
https://wiki.teltonika-gps.com/view/FMC125_Manual_Geofence_settings
FMC125 Manual Geofence settings
FMM125 Terminal Tracker
Main Page > Professional Trackers > FMM125 > FMC125 Configuration > FMC125 Manual Geofence settings
FMC125 has 50 configurable Geofence zones and it can generate an event when a
defined Geofence zone border is crossed. Frame border is an additional border
around Geofence zone used to prevent false events when object stops on the
border of the area and as a result records are made inside and outside the
defined area because of GNSS errors. The event is generated only when both
(Geofence and frame) borders are crossed. See figure to the right for details:
blue track is considered to have entered the area whereas red track is not.
Shape can be a rectangle or a circle as defined by the user.
Priority of Geofence event is categorized into Low, High or Panic levels.
These levels define the priority of event information that is sent to the
server. For more details about priorities look in I/O settings
section.
Generate event allows to choose when record will be generated.
Eventual records controls where scenario status value appears: when disabled
it will exist in each AVL record and when enabled the value will be appended
only to eventual records.
OverSpeeding helps to configure OverSpeeding scenarios separately for each
different Geozone.
Regular OverSpeeding and geozones’ OverSpeeding function independently. If
digital output control is enabled in a regular OverSpeeding scenario, geozones
OverSpeeding scenario will control it too i.e when the device is in more than
one geozone and OverSpeeding is detected in any zone then the digital output
turns on. Digital output turns off only when OverSpeeding is not detected
anywhere.
X1 is used to set geofence zone left bottom corner X coordinate (longitude)
whereas Y1 is used to set Y coordinate (latitude).
X2 or R are used to set accordingly geofence zone upper right corner X
coordinate (longitude) when Rectangular zone is used or circle radius when
Circular zone is used. Y2 sets geofence zone upper right corner Y coordinate
(latitude) for a Rectangular zone.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>