BE COOL BC50TFWTS Schuss Home Electronic Fan Instruction Manual
- June 4, 2024
- BE COOL
Table of Contents
BE COOL BC50TFWTS Schuss Home Electronic Fan Instruction Manual
CONGRATULATIONS!
THANK YOU FOR CHOOSING A PRODUCT FROM BE COOL.
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION, OPERATION OR MAINTENANCE. PROTECT YOURSELF AND OTHERS BY FOLLOWING THE SAFETY INSTRUCTIONS. FAILURE TO FOLLOW INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE AND/OR LOSS OF WARRANTY COVERAGE!
**IMPORTANT SAFETY, LOCATION AND ELECTRICAL CONNECTION INFORMATION.
**
Intended use
The fan is designed exclusively for the ventilation of dry rooms.
It is intended for private use only and is not suitable for commercial use.
Only use the fan as described in these operating instructions
- Only use this appliance in accordance with the guidelines in the operating instructions. Any other use not recommended by the manufacturer could result in fire, electric shock or personal injury.
- Remove the packaging and make sure that the unit is not damaged. If in doubt, do not use the unit and contact the service centre or your dealer.
- Keep children away from packaging materials. There is a danger of choking if swallowed!
- If the power supply cable is damaged, it must be replaced by the manufacturer or an authorised service centre in order to avoid all possible risks.
- Before connecting the appliance to the mains, check that the type of current and mains voltage correspond to the specifications on the appliance type plate.
- The electrical socket in which you connect the unit must not be defective or loose and must be suitable for the required current load and, above all, reliably earthed.
- Avoid using an extension cord as it could overheat and cause a fire.
- It is forbidden to adapt or modify the characteristics of this appliance in any way and use only spare parts and accessories recommended by the manufacturer (failure to do so will invalidate the guarantee and warranty).
- If the unit has a defect, switch it off and contact your dealer or the customer hotline.
- Always and only contact customer service centres authorised by the manufacturer for any repairs to the appliance, mains plug or cable. You can find the service centres online at www.becool.at.
- Children under the age of 8 and persons with reduced physical, mental, sensory or spiritual capabilities or lack of experience and knowledge should not use this appliance unless they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
- Do not operate the unit unattended. If you leave the room, always switch off the unit.
- Children must not play with the appliance.
- Do not twist or bend the mains cable.
- Do not use the appliance with wet hands.
- Do not use the unit outdoors.
- Never operate the unit in rooms where gas, oil or sulphur are present.
- Do not use the unit near water or high humidity, e.g. in damp basements, next to swimming pools, bathtubs or showers. Make sure that no water enters the unit.
- Do not place any objects on the unit.
- Place the unit on a stable and level surface.
- Never cover the unit
- Never insert fingers, pens or other objects into the unit and make sure that the air inlet and outlet are never blocked.
- Always switch off the appliance before unplugging it from the mains.
- Do not pull on the mains cable to disconnect the appliance from the mains power. Always pull on the plug to unplug the mains cable.
- Do not handle the plug with wet hands to avoid electric shock.
- Unplug the appliance when you are not using it, before cleaning it, when it needs maintenance or when it is moved from one place to another.
- Keep the unit in good condition by maintaining and cleaning the unit. If you have any questions about maintenance, you can contact the customer hotline/service centre authorised by the manufacturer.
- Keep and store the appliance in a safe, dry place out of reach of children when not in use.
Recycling, disposal, declaration of conformity
| _ _RECYCLING__ The packaging materials can be recycled. Therefore, it
is recommended to dispose of them in sorted waste.
---|---
| _ _DISPOSAL__ The symbol “crossed-out dustbin” requires the separate
disposal of waste electrical and electronic equipment (WEEE). Electrical and
electronic equipment may contain hazardous and environmentally dangerous
substances. Therefore, do not dispose of this in unsorted residual waste, but
at a designated collection point for waste electrical and electronic
equipment. By doing so, you will contribute to the protection of resources and
the environment. For more information, please contact your dealer or local
authorities. Directive 2012/19/EU
| _ _BATTERY DISPOSAL__ In accordance with Legislative Decree 188 of 20
November 2008 transposing Directive 2006/66/EC on batteries, accumulators and
related waste, the crossed-out wheeled bin symbol on the battery indicates
that it is prohibited to dispose of waste batteries in household
waste.Batteries and accumulators contain highly polluting substances. The user
is obliged to dispose of used batteries at the collection points in the
municipality or in the appropriate containers. The service is free of charge.
In this way, the legal requirements are met and the environment is
protected.You will find these signs on batteries: Li = battery contains
lithiumAl = battery contains alkaliMn = battery contains manganeseCR 2025
(Li); AA (Al, Mn); AAA (Al, Mn)
| DECLARATION OF CONFORMITY We hereby confirm that this article
complies with the basic requirements, regulations and directives of the EU.
You can view the detailed declaration of conformity at any time under the
following link: https:// www.schuss-home.at/downloads
Technical information
If the fan has to be stored for a long time and is not used regularly, place
the fan in its original packaging in a dry place. When using it for the first
time after a long period of inactivity, make sure that the fan is clean and
the motor blades are unrestricted (unit not powered).
Preparation
Before you start assembling the product, make sure that all parts are present.
Included in the delivery: fan housing, fan foot (base) and remote control.
Estimated assembly time: 15 minutes
Assembly
Step 1 : Select the two halves of the base, align the groove and join
themtogether to form a complete unit. Make sure that both halves of the base
fit together properly.
Step 2 : Remove the fixing screw from the bottom of the fan housing,
unwind the power cable and pass it through the hole in the fan base. Then add
the base and rotate it to ensure that the two slots are perfectly aligned with
the housing.
Step 3: Tighten the fixing screw (clockwise) and allow the power cable to
pass through the cable duct on the edge of the base to make the product
flatter and more stable. You have now completed the assembly of the tower
fan.
Note: Please note that it is normal that the tower fan with swivel
function may wobble slightly or appear unstable. This is to ensure that the
fan does not immediately fall over when touched and that it performs the
swivel function properly.
Remote control
Preparing the remote control – Inserting or replacing the battery
Please follow the instructions below:
Initial operation:
To operate the remote control for the first time, please pull out the plastic
protector from the battery compartment on the back of the remote control.
Change battery:
Pull out the battery holder on the back of the remote control and remove the
old battery from the holder:
Now insert a new CR2025 battery, always paying attention to the polarity
markings (+/-) on the battery and the battery holder.
Then push the battery holder fully back into the remote control.
Remote control:
A: On/Off button
B: Speed button
C: Oscillation button
D: Timer button
E: Ion functon
F: Mode button
**Control panel
**
ON/OFF button:
Press the ON/OFF button to switch the unit on or off.
SPEED button:
When operating the fan, press the Speed button to set the speed to low, medium
or high to .
MODE button (3):
3 different wind modes can be selected: normal, natural and sleep mode.
A) Normal wind: Separate operating modes for low, medium and high wind
strength.
Strong
Medium
Easy
B) Natural wind: Changes the fan speeds randomly between the 3 speeds as
follows:
C) Sleep wind: Will cycle the fan speeds. The cycle depends on the fan
speed setting as follows:
Strong
Medium
Easy
TIMER button:
The setting is from half an hour to 1 hour and up to 7.5 hours. Each
additional button press adds half an hour until a maximum of 7.5 hours is
reached. You can orientate yourself accordingly by the LED display on top of
the tower fan.
SWING button:
Press the button to activate the fan’s swivel function. Press again to
deactivate the swivel function.
ION button:
The tower fan starts to generate negative ions, which are used to improve the
air quality in the room.
Note: Negative ions are tiny charged particles that are released into the air. They can help remove dust, allergens and other harmful particles from the air by attracting them and pulling them to the ground. In addition, negative ions can also help reduce unpleasant odours and create fresher, healthier indoor air. This contributes to an overall improved air quality and a more pleasant indoor climate
CLEANING
NOTE:
Always disconnect the mains plug from the socket before cleaning the
appliance.
- DO NOT immerse the unit in water or spray it with other liquids.
- DO NOT use solvents or other chemical products for cleaning. Store the fan in a dry place when not in use.
- When you stop using the fan at the end of the season, wipe off the dust to keep it in good condition for the next season. If necessary, dismantle the grille and remove the fan; clean it with a soft, damp cloth.
Technical information
Rated voltage| 220-240V~
Frequency| 50/60 Hz
Nominal power| 85 Watt
Sound level| 58 dB(A)
Dimensions| 360 × 1270 × 360 mm
Weight| 6 kg
Contact addresses for further information and
service line:| Schuss Home Electronic GmbH Scheringgasse 3, A-1140
Vienna Tel: +43 (1) 97 0 21 – 0www.becool.atFB-No:
236974 t / FB-Court: Vienna
GUARANTEE
With this quality product from BE COOL, you have made a decision for
innovation, durability and reliability.
For this BECOOL appliance we grant a guarantee period of 2 years from the date
of purchase, valid in Austria! If, contrary to expectations, service work
should nevertheless be necessary on your appliance during this period, we
hereby guarantee to repair it free of charge (spare parts and labour) or (at
the discretion of Schuss) to exchange the product. If neither repair nor
exchange is possible for economic reasons, we reserve the right to issue a
credit note for the current value.
In the case of air conditioners, please contact the customer hotline as a
first step (see sticker on the unit or cover page of the operating
instructions), in the case of fans, please contact your specialist dealer or
us directly. We would like to point out that repair work that has not been
carried out by the authorised contract workshop in Austria will immediately
terminate the validity of this warranty.
This warranty does not cover:
- We do not accept any liability for consequential damage in the event of improper use.
- Repair or replacement of parts due to normal wear and tear
- Damage due to non-observance of the operating instructions
- Devices that are used – even only partially – for commercial purposes
- equipment mechanically damaged by external influence (fall, impact, breakage, improper use, etc.) as well as wear and tear of an aesthetic nature.
- Equipment that has been improperly handled
- Units that have not been opened by our authorised service workshop.
- Damage caused as a result of improperly closed condensation drain valves of air conditioners or improperly inserted water tank.
- Consumer expectations not met.
- Damage caused by force majeure, water, lightning, overvoltage.
- Units where the type designation and/or serial number on the unit has been changed, deleted, made illegible or removed.
- services outside our authorised workshops, the transport costs to an authorised workshop or to us and back, and the associated risks.
We expressly point out that within the warranty period, a lump sum of € 60,-
(indexed basis CPI 2010, June 2015) will be charged in case of operating
errors or if no error was detected. The provision of warranty service (repair
or replacement of the appliance) does not extend the absolute warranty period
of 2 years from the date of purchase.
The 2-year warranty is only valid on presentation of the purchase receipt
(must contain the name and address of the dealer as well as the complete
designation of the unit) and the corresponding warranty certificate, on which
the type of unit as well as the serial number (visible on the box and on the
back or bottom of the unit) must be noted! Without the guarantee certificate,
only the legal guarantee applies!
We expressly point out that the statutory warranty rights are not affected by
this guarantee and continue undiminished.
Schuss Home Electronic GmbH and its vicarious agents shall only be liable for
damages in the event of gross negligence or intent. Liability for loss of
profit, expected but not realised savings, consequential damage and damage
from third party claims is excluded in any case. Damages to or for recorded
data are always excluded from the liability for damages
Congratulations on your choice. We hope you enjoy your BE COOL appliance!
ADDRESS
Schuss Home Electronic GmbH
A-1140 Vienna, Scheringgasse 3
Tel.: +43 (0)1/ 970 21
Type designation :………………………………….
Serial number: ………………………………………
In the event of a warranty claim, this warranty certificate must be handed
over to the authorised service centre together with the unit. 
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>