Anker Wireless Mouse 98AN01BA (ET-2240) User Manual
- June 2, 2024
- Anker
Table of Contents
USER MANUAL
Before use:
- Find the wireless mouse and Nano receiver in package
- Plug Nano receiver to USB port on PC
- 1PCS AA battery into Mouse body Properly
- LED indicator will keep flash for few seconds, the Mouse is ready to work.
Advanced function
-
CPI adjustable function
With 5 adjustable CPI 800/1200/1600/2000/2400, factory setting is 1200CPI. Press the switch button on top of Mouse can easy to adjust CPI. LED indicator will flash one time while it converting to 800CPI, LED will flash twice while it converting to 1200CPI, LED will flash three times while it converting to 1600CPI. -
Saving power mode and power switch off
If mouse is stay out of work for 8 minutes, it will turn to power saving mode, press any button to restart it.
If you turn off PC or take out Nano receiver from USB port, press any button or move the mouse to enter the power saving mode, -
Nano receiver: A very small size design for Nano receiver, it can be plug and stay on USB port of PC/Notebook without interference.
Portable design for travel, Nano receiver can be plug in the slot on bottom of mouse
Reconnection
Both of mouse and Nano receiver has a built-in code, It can be setting one mouse to one receiver, or few of mouse to one receiver. Mouse and receiver need to reconnect under the condition of High temperature, high magnetic, strong vibrate.
- Plug off nano receiver from USB port, and plug it on
- Reinstall the battery
- You can use it by reconnection
Remark
- Design by approval IR motion detect technology
- Data transfer by 2.4G wireless connection in 10 meters operating range, working range willlessthan10metersifthere isphysics bother
Caution
- Any amendment unauthorized is not allowing.
The manual of Japanese version will be supplied in Japanese as well at the time of use.
FCC STATEMENT : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there isno guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouragedto try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Anker-Wireless-Mouse-98AN01BA-ET-2240-Manual- Optimized.pdf
Anker-Wireless-Mouse-98AN01BA-ET-2240-Manual- Original.pdf