Silhouette CUT-MAT-ES-LTR Electrostatic Mat User Manual

Silhouette CUT-MAT-ES-LTR Electrostatic Mat User Manual

Safety Precautions

Note
• Before using the product, read this manual well and use the product safely and correctly.
• Do not use the electrostatic mat in a wet or high-humidity environment or with wet hands. Doing so may cause electric shock.
• The precautions listed here contain important information on safety, so make sure you observe them thoroughly.

Precautions on Use

• For details on how to use the cutting machine, refer to the User’s Manual of the machine.
• If you are using the electrostatic mat, be sure to use the electrostatic protection sheet.
• If air enters the gap between the electrostatic mat and the media when loading the media, let the air out before drawing a diagram.
• Periodically wipe the electrostatic mat lightly with a dry, soft cloth.
• Be careful not to damage the surface of the electrostatic mat.
• The electrostatic protection sheet is an expendable item. Please replace it regularly.
• If you are using the electrostatic mat, do not fold the electrostatic protection sheet.
• The method to load the media and tools differs depending on the machine model. For details, refer to the User’s Manual of each model.
• The matters described in this Supplies Manual may change without warning.

About Electrostatic Mats

The electrostatic mat that can be used differs depending on the model.

• It is an expendable item, so it needs to be replaced regularly.

Overview

This is used to secure the media through electrostatic suction.

Supported Models
Portrait4 and CAMEO5

How to Install and Remove the Electrostatic Mat

The installation method differs depending on the model.

Additional Information
The electrostatic mat is individually connected to the cutting machine.

For Portrait4

For CAMEO5

How to Secure the Media

Note

To prevent the generation of an electrostatic charge, be sure to place the electrostatic protection sheet over the electrostatic mat during use.

Additional Information
• Some media cannot be secured depending on the material. In such a case, use a masking tape to secure it.
• If air enters the gap between the electrostatic mat and the media when loading the media, let the air out before drawing a diagram.

For Portrait4

For CAMEO5

How to Replace the Electrostatic Mat Roller Guard Tape

If the cutting does not have the proper finish, the roller guard tape may be worn or deteriorated.
Follow the procedure below to replace the tape.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>