ANKER A8804 USB-C Portable Magnetic Charger for Apple Watch User Guide
- October 30, 2023
- Anker
Table of Contents
ANKER A8804 USB-C Portable Magnetic Charger for Apple Watch User Guide
Connecting to Power
Charging Your Apple Watch
USB-C Portable Magnetic Charger For Apple Watch
Model: A8804
Input: 5V 1A
Output: 5V 1A (MAX)
Radiated H-Field: -36.2 dBuA/m(@10m) (Only for EU&UK)
TX/RX Frequency Range： 326.5kHz
Radiated H-Field: -39.4 dBuA/m(@10m) (Only for EU&UK)
TX/RX Frequency Range： 1.778MHz
IC RF exposure statement:
This equipment complies with IC Radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 10cm between the product and your body.
GB Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A8804 is in
compliance with Radio Equipment Regulations 2017 and The Restriction of the
Use of Certain Hazardous Substances in Electrical and Electronic Equipment
Regulations 2012. The full text of the GB declaration of conformity
isavailable at the following internet address: https://www.anker.com
The following importer is the responsible party (for UK matters only). Anker
Technology (UK) Limited I GNR8, 49 Clarendon Road, Watford, Hertfordshire,
WD17 1HP, United Kingdom
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help
FCC RF Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>