radioshack 2309273 10000MAH Wireless and Type-C Power Bank User Manual

June 1, 2024
RadioShack

radioshack 2309273 10000MAH Wireless and Type-C Power Bank

Product Information

Specifications:

  • FCC ID: 2BDXE-2309273
  • Compliance: Part 15 of FCC Rules
  • Radiation Exposure Limits: FCC compliant for an uncontrolled environment
  • Minimum Distance: 0mm between radiator and body

Product Usage Instructions

FCC Compliance

This device complies with Part 15 of the FCC Rules, ensuring it meets regulatory standards for operation.

Interference Management
Ensure the following to prevent interference:

  1. Avoid causing harmful interference with other devices.
  2. Accept any interference received to maintain smooth operation.

Equipment Placement
To optimize performance:

  • Reorient or relocate the receiving antenna if needed.
  • Increase the separation between equipment and receiver for better signal reception.
  • Connect the equipment to a different circuit than the receiver’s.

Radiation Exposure

To comply with FCC radiation exposure limits:
Operate the equipment with a minimum distance of 0mm between the radiator and your body.

Frequently Asked Questions (FAQ)

  • Q: What should I do if I encounter interference while using the device?
    A: If you experience interference, try repositioning the antenna, increasing the distance between devices, or consult a professional for assistance.

  • Q: How do I ensure compliance with FCC radiation exposure limits?
    A: Maintain a minimum distance of 0mm between the equipment’s radiator and your body during operation.

Thank you for purchasing our 10,000mAh wireless & Type-C power bank.
Please read the manual for instructions and precautions.

OVERVIEW

  1. Power button
  2. USB-C port
  3. USB-A port
  4. LED indicator
  5. Wireless charger

SPECIFICATION

  • Capacity: 1000mAh| 37Wh / Wireless 10W
  • Input: Type-C: 5V/3A, 9V/2A, 12V/1.5A
  • Output: Type-C: PD-20W 5V/3A,9V/2.22A, 12V/1.67A
  • Total output: 5V/3A, Wireless: 10W
  • USB: 5V-6.5V/3A, 6.5V-9V/ 2A, 9V-12V/1.5A
  • Size: 82x82x25mm
  • Weight: 220g

Charge power bank

  • If you are using the product for the first time after purchasing it, please charge the product before using it.
  • Connect one side of the Type-C cable to the power bank, the other size of the cable to a computer, wall chargers, or charger chargers
  • The power is turned on, after that, all the LED’s blink, when then the charging starts after displaying the charge level of the product.

Wired & wireless charge

Wired charge

  • Connect the USB cable to the USB port of the product and then connect it to the device (mobile, tablet, etc) you want to use.
  • All the LED’s are blinking, the current charge is displayed and the power is turned on
  • Please use it according to the external port type of the device you use

Wireles charge

  • Press the power button of the product to turn it on.
  • Check for green light and place your device on the wireless charger, when the product and device’s wireless charger contacts, charging begins.
  • When charging is complete, disconnect the device used by the product.
  • Be careful if you put it on the product with conductive materials (metallic materials, magnets, credit cards, etc)
  • Please check if your wireless charging device supports wireless charging

LED indicator
power bank can check the remaining charge through the LED indicator

radioshack 2309273-10000MAH-Wireless-and-Type-C-Power-Bank-FIG-
\(3\)

Press the power button and check the green light first

  1. WIRELESS CHARGE
  2. WIRED CHARGING

Warnings

  1. Never leave a charging battery unattended. Causes performance degradation and discharge of the product.

  2. Do not expose the power bank to excess humidity or liquids

  3. Do not damage or puncture the casing of the power bank. This may cause overheating, fire or an explosion

  4. Do not expose the power bank to sources of heat, including radiators, stoves or fires.
    Do not be exposed to ambient temperatures above 40°C, such as in a car on a hot day or in direct sunlight. Failure to do so may cause overheating, fire, or explosion

  5. Do not use in a strong electrostatic or electromagnetic environment, including near microwaves as this may shorten the device’s life

  6. If the power bank emits an odor, or excessive heat or becomes discoloured or distorted, please discontinue use immediately

  7. Refer all servicing to qualified service personnel, which is required, if the power bank is damaged in any way, is exposed to liquid or does not operate normally, please do not attempt to service or open the device. This may cause overheating, fire or an explosion

  8. At the end of the devices life, please dispose of this product at a battery recycling station. It is not suitable for domestic waste disposal

  9. If a new power bank is not used for three months or more, its battery capacity will be reduced but will restore to normal capacity after 3-4 charge and discharge cycles

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that may cause undesired operation.
Warning : Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0mm between the radiator & your body

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals