radioshack WC133 Foldable Wireless Charger User Manual
- June 1, 2024
- RadioShack
Table of Contents
radioshack WC133 Foldable Wireless Charger
Product Usage Instructions
Applicable Devices
- Devices with built-in wireless charging receivers (iPhone X, iPhone 8, iPhone 8 plus, Samsung Galaxy S6/ S6 edge/ S7/ S7 edge/ S8/ S8+ / S9/ S9+ / S10 and others)
- Devices must be QI standard.
Advice on Use of Vertical Wireless Chargers
- Mobile phone cases made of metal are not allowed for wireless charging.
- Contact customer service if the charging phone temperature exceeds 60oC (140oF) due to heat generated during charging.
Safety Information
- Avoid using the device if it is overheated.
- Avoid storing the device near heat sources or high-pressure containers.
- Avoid dropping or causing impacts to the charger or the device. Store the device on flat surfaces.
- Ensure children use the device properly.
- Keep the device dry to prevent damage caused by humidity or liquids.
- If the device gets wet, dry it with a towel and seek service center assistance.
- Do not disassemble, modify, or repair the device.
- Avoid placing magnetic stripes or chip cards too close to prevent magnetic failure.
- Maintain a distance of at least 20cm between implantable medical devices and the wireless charger to prevent interference.
- To completely turn off the product, unplug it from the wall socket.
FAQ
Q: Can I use a metal phone case with a wireless charger?
A: No, mobile phone cases made of metal are not allowed for wireless charging as they can interfere with the charging process.
Q: What should I do if my device overheats while charging?
A: If the temperature of the charging phone exceeds 60oC (140oF), please contact customer service for guidance.
Thank you for purchasing RadioShack’s foldable wireless charger
Connect to the Power Adapter
- Connect the power adapter to a socket.
- Connect the adapter to the USB 2.0 interface and the other Type-C to the wireless charger. Stand by state: LED light is off.
- Turn on: The LED light turns on for 2 seconds and then goes off. Charging: LED light turns on.
- Other: LED light will be blinking once a second until foreign objects are away.
- Full charging: Green LED show on (Suitable for some models). The involved images are sketch maps, end product is subject to change.
- Includes: Wireless charger, charging cable, and user manual.
Specification
- Input: DC 5V 2A, DC 9V 1.67A, DC 12V 1.5A
- Charging Efficiency: more than 73%
- Charging distance: 4-8mm
- Frequency: 110-205Khz
- Wireless Charging Power: 15W/10W/7.5W/5W
- Compatible Standard: QI
Applicable Devices
- Devices with built-in wireless charging receiver (iPhone X, iPhone 8, iPhone 8 plus, Samsung Galaxy S6/ S6 edge/ S7/ S7 edge/ S8/ S8+ / S9/ S9+ / S10 and others)
- Devices must be QI standard.
Advice on Use of Vertical Wireless Chargers
- Mobile phone cases made of metal are not allowed for wireless charging.
- Please contact customer service if the temperature of the charging phone is over 60 (140oF). Because the heat is created while charging.
- Please remove your mobile phone case while charging to improve the charging efficiency and cool the device.
- Under the principle of magnetic induction coil, barriers and distance over 6mm between the phone and the charger will reduce the charging efficiency and increase heat.
- The wireless charger stand will reduce the charging power or cut off the power automatically and work again after the temperature is lower than 60oC (140oF). Because the temperature of wireless chargers and mobile phones goes up with the time of charging.
Safety information
- To prevent injury to yourself and others or damage to your device, read the safety information about this device. Do not use your device for a while if the device is overheated.
- Prolonged exposure of your skin to an overheated device may irritate you.
- Do not store your device near or in heaters, microwaves, hot cooking equipment, or high-pressure containers, your device may overheat and cause a fire.
- Do not drop or cause an impact on the charger or the device. Store your device only on flat surfaces
- If children use the device, make sure that they use the device properly.
- Keep your device dry
- Humidity and liquids may damage the parts of electronic circuits in your device.
- If your device is wet, dry the device with a towel and take it to a service center.
- Do not disassemble, modify, or repair your device.
- Do not place too close a magnetic stripe or chip card to avoid magnetic failure.
- Please keep a distance of at least 20cm between implantable medical devices and the wireless charger, to avoid potential interference with the medical device.
- To turn this product off completely, you must pull the power plug out of the wall socket.
- Consequently, the power plug must be easily and readily accessible at all times.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a class B digital device, according to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used under the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. if this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver ult the (connected)e(d)a(.)ler or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements, This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>