iBoard IB-219C 6in Stainless Steel Black Running Boards Instruction Manual
- June 1, 2024
- iBoard
Table of Contents
iBoard IB-219C 6in Stainless Steel Black Running Boards
READ INSTRUCTIONS CAREFULLY BEFORE START ING INSTALLATION. REMOVE CONTENTS FROM BOX AND VERIFY ALL PARTS ARE PRESENT. ASSISTANCE IS RECOMMENDED.
ROCKER PANEL MOUNT
NO DRILLING REQUIRED
PART LIST
| Fastener Size | Tightening Torque (ft-lbs) | Required |
|---|---|---|
| 6mm | 6-7 | X |
| 8mm | 16-18 | √ |
| 10mm | 31-32 | √ |
| 12mm | 56-58 | X |
| 14mm | 92-94 | X |
Mounting Bracket List
Mounting Bracket List
Item| QTY| Description| Item| QTY| Description
1#| 2| Driver/Passenger Front Mounting Brackets| 3#| 6| Adjustment Spacers
2#| 2| Driver/Passenger Rear Mounting Brackets| | |
Hardware Package
Hardware Package A (For Bracket Installation)
Item| QTY| Description| Item| QTY| Description
1#| 4| M10 Bolt Plates| 4#| 8| M8X1.25-35mm Hex Bolts
2#| 4| M10 Large Flat Washers| 5#| 16| M8 Flat Washers
3#| 4| M10 Nylon Lock Nuts| 6#| 8| M8 Nylon Lock Nuts
Hardware Package B (For Stainless Steel Step Bar Installation)
Item| QTY| Description| Item| QTY| Description
1#| 8| M8X1.25-35mm Carriage Bolts| 3#| 8| M8
Nylon Lock Nuts
2#| 8| M8 Large Flat Washers| 4#| 4| Sliders
(Packed with Step Bars)
Installation Instructions
STEP 1
Start installation front the passenger side of the vehicle. Insert (1) M10 Bolt Plate into the rectangular hole and out the round hole in the bottom of the side panel, (Fig 1).
STEP 2
Select the Passenger Front Mounting Bracket. Hold a Passenger Mounting Bracket in place on the outside of the pinch weld and over the Bolt Plate. Attach the Mounting Bracket to the M10 Bolt Plate with the included (1) M10 Large Flat Washer and (1) M10 Nylon Lock Nut, (Fig 3). Leave loose at this time.
NOTE: Make sure that the mounting tab on the Bracket is on the outside of the pinch weld.
Line up the (2) holes in the Bracket with the factory holes in the pinch weld. Attach the Bracket to the pinch weld using the included (2) M8X1.25-35mm Hex Bolts, (4) M8 Large Flat Washers and (2) M8 Nylon Lock Nuts, (Fig 3). Do not fully tighten at this time.
IMPORTANT: The Passenger Front Mounting Bracket is different from the Passenger Rear Mounting Bracket, (Fig 2). Use the instructions to correctly identify the Brackets.
(Fig 2) Passenger Side Mounting Brackets
(Fig 3) Passenger Front Mounting Bracket Installation
STEP 3
Move to the Passenger Side Rear Mounting location. Repeat Steps 1—2 to install the Passenger Rear Mounting Bracket, (Fig 4). Do not fully tighten at this time.
(Fig 4) Passenger Rear Mounting Bracket Installation
STEP 4
NOTE: Depending on the vehicle, model and year, the front of the running
board may by close to or make contact with front factory flares. If necessary,
insert 1 to 3 of the Adjustment Spacers between the Bracket and the outside of
the pinch weld as needed to adjust the fitment of the Side step bar, (Fig 5).
STEP 5
Once all (2) Passenger side mounting brackets are installed, then proceed to the Step Bar installation. (Figs 6 & 7)
- Select (1) Slider and (2) M8X1.25-35mm Carriage Bolts;
- Install (2) M8X1.25-35mm Carriage Bolts in (1) Slider.
- Slide the Slider (with carriage bolts) to the Step Bar.
- Repeat to install the other (1) slider to the step bar.
- Attach the Step Bar (with the Sliders) onto the installed mounting brackets. Position the Sliders to the installed brackets. Secure the Step Bar to the installed Brackets by using (4) M8 Large Flat Washers and (4) M8 Nylon Lock Nuts and (2) Sliders, (Fig 7). Do not fully tighten hardware at this time.
Note: The Sliders are packed with the Step Bars.
Level and adjust the Step Bar and fully tighten all hardware. Repeat Steps 1-5 for the other side Step Bar installation. The installation is completed!!!
Attention
Do periodic inspections to the installation to make sure that all hardware
is secure and tight.
In order to protect your bars/boards, please use mild soap/non-abrasive
products for cleaning only.
(Fig 6) Slider Installation
(Fig 7) Step Bar Installation
Customer Support
Scan for Installation Video
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>