radioshack 2733350 Cell Phone Stand With Wireless Charger User Manual
- June 1, 2024
- RadioShack
Table of Contents
radioshack 2733350 Cell Phone Stand With Wireless Charger User Manual
INSTRUCTIONS FOR USE
- Plug the power adapter into the socket. One section of the USB power cable is connected to the adapter and the other is connected to the wireless charger
- Place the mobile device that supports wireless charging on the charging area of wireless charging
- Remove the mobile device after fully charged
Note: This product supports 15W fast charging function. For better experience, please use QC3.0 and above
INDICATOR DESCRIPTION
- Power ON: The red and blue light flashes 1 time, and then goes off to enter thestand-by state.
- Charging: Steady red warning light
Foreigh object detection: flashes continuously until the product is removed, and the flashing is cancelled
PRECAUTIONS
-
Do not squeeze or hit the object with force
-
Do not disassemble or modify by yourself
-
Do not use it near hot or hot objects, and do not use it in high temperature, humid, oily environment
-
Do not place it too close to magnetic cards (ID cards, bank, cards, etc) with magnetic strips or chips to avoid magentic fallure
Do not place metal or metal phone cases on the wireless charge -
Do not place metal or metal phone cases on the wireless charger
-
Please keep the distance between the implanted medical device (new pacemaker, implantable cochlea, etc.) and the wireless charger at least 20cm to avoid potential interference with the medical device
-
Do not shred or pierce this product with metal, do not burn or discard it in water
-
Do not short circuit this product
-
Unplug the power supply when not using the product, and store it in a dry and ventilated place
PRODUCT PARAMETERS
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1)This device may not cause harmful
interference. (2)This device must accept any interference received, including
interference that may cause undesired operation.
2.Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radiofrequence energy and,if not
installed and used in accordance with the instructions,maycause harmful
interference to radio communications.
However,there is no guarantee that interference will not occur in a particular
installation.if this equipmemt does cause harmful interference to radio or
television reception,which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an autlet on a circuit different from that to which thereceivler or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement,This equipment should be installed and operated with a minumum distance of 20 cm between the radiator and your body.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>