UBIQUITI U6PLR UniFi + plus Long Range Access Point User Manual
- June 11, 2024
- UBIQUITI
Table of Contents
U6PLR UniFi + plus Long Range Access Point
User Manual
U6PLR UniFi + plus Long Range Access Point
FCC ID: SWX-U6PLR
IC ID: 6545A-U6PLR
Ubiquiti Inc. will be incorporating the E-Label procedures per FCC KDB
784748-D02. The information below is what will be included in the E-Labeling.
E-label and warning statements can be found in the device/controller GUI under
Device > Settings > About.
Detailed compliance information including Declaration of Conformity is
available at the following internet address:
ui.com/compliance
FCC
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions.
This device may not cause harmful interference, and This device must accept
any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ISED Canada
CAN ICES-3 (A) / NMB-3 (A)
This device complies with ISED Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Warning
The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be located
or operating in conjunction with any other antenna or transmitter.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>