KENDAL LIGHTING MSAS05-BLK Magnetic Track Surface Pendant Instruction Manual
- June 13, 2024
- KENDAL LIGHTING
Table of Contents
WITHOUT FLANGE TRACK
TRACK CORNER INSTRUCTIONS
MSAS05 CROSS CORNER
ACCESSORIES REQUIRED:
KENDAL MODEL MSAS05
WHICH INCLUDES: 4x MSAPINS
4 x MSAQ2 connectors
KENDAL MODEL MSA01 POWER PLATE IF REQUIRED
DIMENSIONS
STEP 1 REMOVE END CAP FROM TRACK STEP 2 REMOVE DECORATIVE PLATE. IF
CONNECTING TO END OF TRACK THAT DOES NOT HAVE A DECORATIVE PLATE SKIP TO STEP
5. STEP 3 REMOVE MAGNET STEP 4 INSERT THE MSA01 POWER PLATE(d) – SOLD
SEPARATELY STEP 5 INSTALL THE MSA22 PIN SET(b) INTO THE PIN CONNECTOR
HOLES (c) ON THE TRACK. SLIDE THE TRACK CONNECTOR (a) INTO THE SLOT ON THE
BACK OF THE TRACK SO THAT THE HOLE ON THE CONNECTOR LINES UP WITH THE SECOND
HOLE IN FROM THE END OF THE TRACK AND SECURE WITH 3 SET SCREWS(SEE INSET
PICTURE). STEP 6 SLIDE MSASO5 TRACK CORNER ONTO THE TRACK CONNECTOR (a)
WHILE CAREFULLY LINING UP THE PIN SET WITH THE PIN SET HOLES ON THE MSAS04
TRACK CORNER. ATTENTION:
WHEN JOINING TRACKS OR ACCESSORIES UTILIZING PIN CONNECTORS, MAKE SURE PINS
ARE HORIZONTAL AND LINE UP WITH PIN CONNECTOR HOLES. YOU MAY NEED TO GENTLY
PUSH UP OR DOWN ON THE PINS SO THEY LINE UP CORRECTLY. FAILING TO DO THIS MAY
RESULT IN PINS MISSING THE PIN CONNECTOR HOLES AND LOSS OF THE 24 VOLT
CONNECTION. STEP 7 SECURE OTHER END OF TRACK CONNECTOR (a) TO THE TRACK
CORNER WITH REMAINING SET SCREW STEP 8 REPEAT STEPS 1 THROUGH 7 FOR OTHER
THREE SIDES OF TRACK CORNER AND COMPLETE TRACK CORNER CONNECTION. NOTE:
AFTER EACH TRACK CONNECTIONA CONTINUITY TEST SHOULD BE DONE TO ENSURE
PROPER ELECTRICAL CONNECTIONS WERE MADE.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>