SEAVIEW PMA5FMT7 Camera Mounts Installation Guide
- June 14, 2024
- SEAVIEW
Table of Contents
SEAVIEW PMA5FMT7 Camera Mounts
Refer to website for most up to date instructions and video WWW.SEAVIEWGLOBAL.COM
PARTS INCLUDED
PMA5FMT7 AND
PMA12FMT7 PARTS
-
PMA5FMT7
-
PMA12FMT7
-
X4
-
X6
-
X4
-
X4
-
x1 Part #SLADAPT3
-
X1
-
M6 x 16
X6 -
¼-20 x 1”
X4
MA5FMH7 AND
PMA12FMH7 PARTS
-
PMA5FMH7
-
PMA12FMH7
-
X4
-
X6
-
X4
-
X4
-
x1
Part #SLADAPT3 -
X1
-
12 x 1”
X6 -
¼-20 x 1”
TOOLS NEEDED
INSTALLATION INSTRUCTIONS
-
Place the foam gasket onto mounting surface and mark the four holes to drill.
-
Using a drill bit drill the four holes for the mounting bolts.
-
Using a hole saw, drill the center hole for the cable.
-
Insert the four nuts into the adapter plate as shown. (This may have already been done for you).
-
For the SLADAPT3 adapter plate you will need to drill a hole in the center for the cable.
-
Route the electronics cables through the hole you just drilled into the SLADAPT3
-
**7A**Insert the six M6x16 bolts and washers through the bottom of the SLADAPT3 and into the camera.
**7B** Using a Philips head screwdriver screw in the six #12×1” screws to
secure the camera to the adapter plate.
-
Apply marine adhesive sealant to the four nylon shoulder washers and then insert into the top plate of the Seaview mount
-
Route the electronics cables through the center hole on the top of the mount.
-
Secure the adapter plate to the mount with the four ¼-20×1” bolts.
-
Place the foam gasket over the bolt holes you drilled in Step #2
-
Route the cabling through the center hole. Place the mount assembly on top of the foam gasket.
-
Apply marine adhesive sealant onto the four nylon shoulder washers. Then insert the washers into the four bolt holes on the base of the Seaview mount.
Tel: 800-655-7922
www.seaviewglobal.com
EUROPEAN OFF
Tel: +33 4 94 53 27 70
www.seaviewprogress.com
References
- Seaview | Leaders In Mounting Solutions For Marine Electronics
- Profitez des meilleurs équipements pour votre bateau