SOLIDWORKS IM 8 Rings LED Ring Pendant Light Installation Guide
- June 20, 2024
- SOLIDWORKS
Table of Contents
SOLIDWORKS IM 8 Rings LED Ring Pendant Light
Specifications
- Indoor use only
- Avoid use in humid places
- Avoid contact with water, liquids, or inflammable products
Safety Instructions
Please read all instructions carefully before installation and use of the
product. Follow safety guidelines to ensure proper installation and
functioning.
Always isolate the power supply before installation, maintenance, or repair to
prevent electrical hazards.
If you have any doubts, consult a qualified electrician for assistance.
Installation
Ensure proper cable installation to prevent damage. Do not allow cables to be
squeezed or damaged by sharp edges during installation.
If the external flexible cable is damaged, it must be replaced by the
manufacturer, their service agent, or a qualified electrician to avoid risks.
Adjusting Cables
- To adjust the direction of round light sources, rotate the pin accordingly.
- To raise the height of the fixture, push up on the cable.
- To lower the height of the fixture, depress the pin into the ceiling canopy using your finger or fingernail and push down on the cable while holding the pin in place.
FAQ :
Q: Can this product be used outdoors?
A: No, this product is for indoor use only. Avoid using it in humid places or
in contact with water or inflammable products.
Installation Manual
Safety Instructions
- Please read this notice carefully and keep it all along the use of this product. Follow the instructions for a safe and correct installation and functioning of the fitting.
- The manufacturer does not accept any responsibility for damage caused by improper installation and service.
- Always isolate the power before commencing installation, maintenance or repair.
- In case of doubts, please contact a qualified electrician.
- This product is for indoor use only. Please do not use it on humid places. Do not put it in contact with water or any liquids or inflammable products. Always respect the minimal distance (indicated on the light) to inflammable products.
- During installation, make sure that the cables will not be squeezed or damaged by sharp edges.
- If the external flexible cable is damaged, it needs to be replaced exclusively by the manufacturer, his service agent, or another qualified electrician. This is to avoid all risks.
How to adjust the cables.
-
rotate the pin to adjust the direction of round light sources, if need be.
-
simply push up on the cable to raise the height of the fixture
-
Using the tip of your finger or fingernail, depress the pin into the ceiling canopy, this will release the cable locking mechanism
-
While holding the pin in place, simply push down on the cable to lower the height of the fixture
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>