SEAVIEW SP2S1 Rail Pods Installation Guide
- June 14, 2024
- SEAVIEW
Table of Contents
SEAVIEW SP2S1 Rail Pods
Product Information
Specifications:
- Compatible Models: SP2S1, SP3S1, SP5S1
- Recommended Sealant: Sudbury Elastomeric Marine Sealant
- Sealant Purchase: Call 800-655-7922 or visit www.seaviewglobal.com
- Tool Needed: Hole Saw (to drill a hole in the rail)
- Recommended Blade: Jigsaw with 10 TPI (Teeth per Inch)
- Bolt Sizes: M6 x 1 x 15mm, M4 x 0.7 x 20mm
FAQ:
-
Q: Where can I purchase Sudbury Elastomeric Marine Sealant?
A: You can purchase Sudbury Elastomeric Marine Sealant by calling 800-655-7922 or visiting www.seaviewglobal.com. -
Q: What type of blade is recommended for cutting with a jigsaw?
A: We recommend using a jigsaw blade with 10 TPI (Teeth per Inch). -
Q: How should I position the rubber gasket during assembly?
A: Make sure the flaps of the rubber gasket are pulled over the outer edge of both pod housings. -
Q: What are the contact details for Seaview’s European office?
A: You can contact Seaview’s European office at +33 4 94 53 27 70 or visit their website at www.seaviewprogress.com.
For further assistance, please call 800-655-7922 or visit www.seaviewglobal.com
PARTS INCLUDED
TOOLS NEEDED
Sudbury Elastomeric Marine Sealant is recommended. To purchase call
800-655-7922 or visit
www.seaviewglobal.com
INSTALLATION
-
use a hole saw to drill a hole in your rail to pass the cables through.
-
Use the appropriate grommet for your application, and place it on the rail. Be sure to align the opening in the grommet with the hole.
-
Install the stainless steel clamp assembly as shown.
-
Secure the clamp with the six M6x1x15mm bolts.
-
Insert the large bolt and rubber ring into the housing as shown.
-
Insert the second rubber ring onto the large bolt. Apply Loctite to the threads as shown.
-
Place the instrument template onto the lid.
-
Trace the template with a pen.
-
Remove the template from the lid.
-
Drill the mounting holes for your instrument. Follow the manufacturer’s instructions for this.
-
Use a jigsaw (10 TPI blade is recommended) and cut the line that you marked in step #8.
Pro Tip: Use masking tape around the area you plan to cut to avoid unwanted marks from the jigsaw. -
Install the instrument and cables.
-
Install the rubber gasket and lid assembly on to housing.
Note: rubber gasket should already be applied to the front face plate .
-
Secure housing assembly with the M4 x 0.7 x20mm and washers.
Tel: 800-655-7922
www.seaviewglobal.com
EUROPEAN OFFICE
Tel: +33 4 94 53 27 70
www.seaviewprogress.com
References
- Seaview | Leaders In Mounting Solutions For Marine Electronics
- Profitez des meilleurs équipements pour votre bateau
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>