SmallRig 3902 Wireless Remote Controller User Manual
- June 1, 2024
- SmallRig
Table of Contents
SmallRig 3902 Wireless Remote Controller
Thank you for purchasing SmallRig’s product.
Warnings
- Do not dismantle it at random as it contains electronic components and do not drop or crash it.
- Keep it out of the reach of children.
- Please avoid high temperature and high humidity when storing or using this product.
- If you have any questions, please contact the platform for after-sales services.
Please do not disassemble the product. If you have any question, please contact the seller to apply after-sales service.
In the Box
- Remote Control x 1
- CR2032 Battery x 2
- User Manual x 1
- 1/4″-20 Screw x 1
- Allen Wrench x 1
Compatibility
Sony: Alpha 7R V / Alpha 7R IV/ Alpha 7R Ill/ Alpha 7 IV/ Alpha 7 Ill/
Alpha 7S Ill/ Alpha 7C/ Alpha 911 / Alpha 9 / Alpha A1 / FX3/ FX30/ Alpha
6700/ Alpha 6600 I Alpha 6100/ Alpha 64()0 / ZV-E1 / ZV-E10/ ZV-1 II/ ZV-1 /
ZV-1 F / OSC-RX1 OOM7
Canon: EDS R5 / R6 Mark II/ R6/ R7 / RB/ R10 / R /RP/ R50 / M6 Mark II/
M50 /900
Nikon: Z50/Zfc/Z30
Product Details
- 1/4″-20 Threaded Hole
- Status Indicator
- Shutter (half-press for autofocus)/ Record Button
- Mode Switch
- Battery Compartment
- Power Switch
- Clip with Cold Shoe Mount
Preparation Before Use
Step 1 : Press the position as shown to remove the battery compartment.
Step
2 : Install the included battery with the ” +” pole facing up.
Pairing Steps
Indicator Light Description
- Battery power 20% ~ 100%: blue light
- Battery power 10% ~ 20%: red light
- Battery power <10%: red light flashing
Remote Control Mounting
-
Clip with Cold Shoe Mount installation:
Through the Clip with Cold Shoe Mount, clamping the equipment with its built- in cold shoe. -
1/4″-20 screw installation: After removing the Clip with Cold
Shoe Mount, fix the remote control to the built-in 1/4″-20 threaded hole device via a 1/4″ -20 screw.
Attention
- The remote control connection procedure may vary from camera to camera, please refer to the remote control section in the camera manual for details.
- The Bluetooth connection range of 100cm / 32.Bin is an estimation, which depends on your surroundings.
- A remote control can only be paired with one camera, if you need to control another camera, refer to the pairing procedure to pair the remote control with the camera you need to control, and the previous camera will be unpaired automatically.
- After successful pairing, the camera and the remote control will connect automatically when the camera and remote control is switched on.
- Please turn off the Power Switch when not in use.
Specifications
- Operating Voltage 3.0V
- Operating Current :≤5mA
- Battery Parameters 3.0V 220mAh 0.72Wh
- Control Range about 10m
- Operating Temperature -10º∼45º
- Product Dimensions 53.2 x 32.4 x 22.5mm
- Net WeiQht 18 ± 5g
- Material(s) ABS+ PC
The data above comes from SmallRig laboratory and may be subject to changing test environment.