global sources GL-TLM030W LED Light Metal Table Lamp with Wireless Charging Pad and USB Port Instruction Manual
- June 5, 2024
- global sources
Table of Contents
global sources GL-TLM030W LED Light Metal Table Lamp with Wireless
Charging Pad and USB Port
Shade Assembly
- Unscrew the socket fastener (C) from the socket arm (B)
- Place the glass shade onto the socket, and while holding the shade in place, screw the socket fastener back onto the socket arm until tight and the glass shade is securely fastened into place.
Wireless Charging:
Please make sure your wirelessly chargeable phone is placed at the center of the wireless charging area, and that it is connected. Phones with metal inside do not support a wireless charge. If your phone does not charge wirelessly, standard USB charging may be used.
BULB TYPE
Includes 1x A19 5W LED bulb.
GENERAL PRODUCT INFORMATION
-
This table lamp is only suitable for use in a dry location.
-
USB power: Max 5V=1A.
-
Wireless charge power: Max 5V=1A.
Extend Your Warranty To Five Years Free
If you would like to extend your warranty from three years to a total of five, free, register your purchase using the brief form on our. site:brightech.com/pages/extended-warranty .
GENERAL PRODUCT INFORMATION
This product is suitable for dry locations only .
IMPORTANT SAFETY INSTRUCTIONS
AS A SAFETY FEATURE TO REDUCE THE RISK OF ELECTRIC SHOCK, THIS LAMP HAS A POLARIZED PLUG. THIS MEANS ONE PRONG IS LARGER THAN THE OTHER. THEREFORE, THE PLUG WILL ONLY FIT IN A POLARIZED OUTLET IN ONE WAY. IF THE PLUG DOES NOT FIT FULLY IN THE OUTLET, TAKE IT OUT AND TURN THE PLUG OVER TO INSERT THE PRONGS IN THE OPPOSITE WAY. IF IT STILL DOES NOT GO IN, CONTACT A QUALIFIED ELECTRICIAN. NEVER USE WITH AN EXTENSION CORD UNLESS THE PLUG CAN BE FULLY INSERTED. DO NOT ALTER THE PLUG.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>