VIVO DESK-V000KL 38 Corner Desk Riser Instruction Manual
- June 17, 2024
- Vivo
Table of Contents
VIVO DESK-V000KL 38 Corner Desk Riser
Product Specifications:
- Product Name : 38 Corner Desk Riser
- SKU: DESK-V000KL/LA/LN/LW
- Weight Capacity : 33 lbs (15kg)
- Desk Weight : 4.4lbs (2kg)
Product Usage Instructions:
Assembly Steps:
- Apply Pads (D) to the underside of the Keyboard Tray (B).
- Install Stopper (F) to the underside of Keyboard Tray (B) using ST4.2x12mm Screws (S-B) and a Phillips screwdriver.
- Press Foot Pads (E) into holes in the base of Desk (A).
- Cut the large plastic ties on the bottom of Desk (A).
- Place Desk (A) right-side up on a table and raise it by squeezing the handle underneath the desktop.
- Place Keyboard Tray (B) on metal brackets on Desk (A) and secure it using M5x10mm Screws (S-A) and a Phillips screwdriver.
- Apply Cable Clips (C) to the underside of the desk assembly.
Product Usage
To raise or lower your desk riser, press the side levers. Lightly press down on the riser when lowering without any weight on the desktop for a smoother process. Apply light pressure when lowering after placing items on the desktop or add additional weight if needed. Note the 33lb weight capacity.
Grommet Installation
If installing a grommet compatible monitor mount, remove the plastic cap from the rear centre of the desktop and follow the mount’s directions for installation.
Tension Adjustment:
If your desk riser lifts too easily or is too difficult, adjust the gas spring cable tension at the base of your riser.
- Loosen the Upper and Lower Nuts using an adjustable wrench until they are on opposite ends of the Gas Spring Cable.
- Option A – Increase Tension: Pull the cable away from the Lever until the Inner Nut is pressed against the middle divider. Tighten Upper Nut firmly to hold the cable in position.
- Option B – Decrease Tension: Push the cable down towards the base until the Upper Nut is firmly pressed against the middle divider.
Frequently Asked Questions
- Q: What tools are needed for assembly?
- A : Scissors and a Phillips screwdriver are required for assembly.
- Q: What is the weight capacity of the desk riser?
- A: The weight capacity is 33 lbs (15kg).
- Q: Is adult supervision required for this product?
- A: Yes, adult supervision is required as there are small parts that can pose a choking hazard for children under 3 years.
WARNING
PACKAGE CONTENTS
TOOLS NEEDED
WARNING: CHOKING HAZARD
SMALL PARTS – NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
INSTALLATION INSTRUCTION
STEP 1
- Apply Pads (D) to underside of the Keyboard Tray (B).
STEP 2
- Install Stopper (F) to underside of Keyboard Tray (B) using ST4.2x12mm Screws (S-B) and a Phillips screwdriver.
STEP 3
- Press Foot Pads (E) into holes in the base of Desk (A).
STEP 4
- Cut the large plastic ties on the bottom of Desk (A). CAUTION: Do not squeeze the release handle with the desk in a sideways or upside-down position.
STEP 5
- Place Desk (A) right-side up on a table. Raise the desk by squeezing the handle underneath the desktop.
STEP 6
- Place Keyboard Tray (B) on metal brackets on Desk (A). Secure the keyboard tray to brackets using M5x10mm Screws (S-A) and a Phillips screwdriver.
STEP 7
- Apply Cable Clips (C) to the underside of the desk assembly.
Assembly Complete
- The desk riser is now ready for use
Press the side levers to raise or lower your desk riser.
When lowering without any weight on the desktop, lightly press down on the
riser as you lower it to allow for a smoother lowering process. If it feels
difficult to lower after placing laptop and other intended setup items, apply
light pressure to lower smoothly or add additional weight.
Please note the 33lb weight capacity when adding weight.
Grommet Installation
- If installing a grommet compatible monitor mount, remove the plastic cap from the rear centre of the desktop. Install the mount to the open hole according to the mount’s directions.
Tension Adjustment
- If your desk riser lifts up or down too easily, or is too difficult, the gas spring cable can be adjusted to your desired tension. The adjustment is located at the base of your riser.
Start by loosening the Upper (1) and Lower (2) Nuts using an adjustable wrench. Loosen the Nuts until they are both on the opposite ends of the Gas Spring Cable.
Tension Adjustment – cont’d
Option A:
Desk Is Difficult to Raise/Lower | Increase Tension
If the desk feels difficult to raise and lower, you will need to increase the
Gas Spring Cable tension. Gently pull the cable away from the Lever until the
Inner Nut (2) is firmly pressed against the middle divider.
Tighten the Upper Nut (1) until it firmly holds the cable in its position, as shown below.
Option B:
Desk Raises/Lowers Too Easily | Decrease Tension
If the desk is raising or lowering without the handle being pressed, the
tension will need to be loosened. Gently push the cable down towards the base
of the riser until the Upper Nut (1) is firmly pressed against the middle
divider.
Tighten the Lower Nut (2) until it firmly holds the cable in its position, as shown below.
CAUTION!
- Keep the monitor and laptop base fully on the desktop
- Follow the cable routing instructions to avoid the potential to pinch cables
- Leave enough slack in the cable to allow for a full range of vertical motion (15” / 38 cm
- Raise desktop slowly to keep items stable
Failure to follow these instructions may result in property damage and/or personal injury.
Open Monday – Friday 7:00 am – 7:00 pm CST, our dedicated support team can offer immediate assistance with rapid response times. If any parts are received damaged or defective, please contact us. We are happy to replace parts to ensure you have a fully functioning product.
CONTACT
309-278-5303 AVG. RESOLUTION TIME (within office hrs): 5M 4S
www.vivo-us.com Chat live with an agent!
AVG. RESOLUTION TIME (within office hrs): < 15 M
AVG. RESPONSE TIME (within office hrs): 1HR 8M
- 23% within < 15m
- 38% within < 30m
- 61% within < 1hr
- 83% within < 2hr
- 92% within < 3hr
Scan the QR code with your mobile device or follow the link for helpful videos
and specifications related to this product.
https://vivo-us.com/products/desk-v000kl
References
- Register a .US.COM domain today!
- VIVO - Desks, Monitor Mounting, and More Home & Office Solutions – VIVO - desk solutions, screen mounting, and more
- 38" Corner Standing Desk Converter – VIVO - desk solutions, screen mounting, and more
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>