MEAN WELL LSP-160 Series Slim Type with PFC Switching Power Supply Owner’s Manual

MEAN WELL LSP-160 Series Slim Type with PFC Switching Power Supply Owner's Manual

Features

• Slim width and low profile (20mm)
• Fanless design for noise free environment
• Withstand 300VAC surge input for 5 seconds
• DC OK active signal function
• Semi-Potting for high moisture environment
• Protections: Short circuit / Over load / Over voltage / Over temperature
• Current sharing for redundant function (5V/ 4.2V/3.3V only)
• Max. operating wattage to 2ooW at 23oV AC input
• Operating altitude up to 5ooo meter (Note.5)
• LED indicator for power on
• 3 years warranty

Applications

• Industrial automation machinery
• Industrial control system
• Mechanical and electrical equipment
• Electronic instruments, equipment’s or apparatus
• Household appliances
• LED display application

Description

LSP-160 series is a 200W Max. single-output slim type power supply with 20mm of low profile design. Adopting the full range 100~264VAC input, the entire series provides an output voltage line of 3.3V,4.2V,5V, 12V, 24V, 36V and 48V. In addition to the high efficiency up to 93.5%, that the whole series operates from -30 ~ 70 under air convection without fan. LSP-160 has the complete protection functions and 5G anti-vibration capability; It is complied with the international safety regulations such as TUV BS EN/EN62368, UL62368 and GB4943. LSP-160 series serves as a high performance power supply solution for various industrial applications.

Model Encoding

SPECIFICATION

Block Diagram

Derating Curve

STATIC CHARACTERISTIC

NOTE: Tc measurement point ,please refer page 5 mechanical specification.

Function Manual

1. DC_OK Signal
   DC_OK is a collector shorted signal. It is used by an optocoupler in the power supply which indicates the output status of the power supply as exhibited below.

2. Redundant function:
   LSP-160 has built-in redundant function and can be connected 2 units in parallel for current sharing.
   ※ Difference of output voltages among parallel units should be less than 0.2V(Can Fine tune by SVR1).
   ※ When in parallel operation the maximum load should not be greater than the rated power.
   ※ When output current<( 30% rate current)×(Number of unit),the current shared among units may not be fully balanced.
   And the LED indicator maybe flash of one of them,but not effecting normal working.

Mechanical Specification

Installation

1.Operate with additional aluminum plate
In order to meet the “Derating Curve” and the “Static Characteristics” ,LSP-160 series must be installed onto an aluminum plate(or the cabinet of the same size) on the bottom. The size of the suggested aluminum plate is shown as below. And for optimizing thermal performance, the aluminum plate must have an even and smooth surface (or coated with thermal grease), and LSP-160 series must be firmly mounted at the center of the aluminum plate.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>