BLAUPUNKT HCS502 Hair Clipper Owner’s Manual
- June 1, 2024
- Blaupunkt
Table of Contents
BLAUPUNKT HCS502 Hair Clipper Owner’s Manual
IMPORTANT NOTES
- Before using this device read the instruction manual and follow the instructions inside. The manufacturer is not liable for any damages caused by the misuse of this device due to inappropriate handling. Please keep this manual for future reference. This device is for domestic use only. Do not use for any other purposes.
- The device should be cleaned regularly complying with the recommendations described in the section on cleaning and maintenance.
- Do not place the device near sources of heat, flame, an electric heating element or a hot oven. Do not place on any other device.
- This equipment can be used by children aged 8 years and over under as long as supervision is provided. People with reduced physical or mental capabilities, as well as people with no previous experience of using this equipment must be supervised and made aware of the risks. The instruction manual should be used as a reference for the safe use of this equipment. Children should not play with the equipment. Children without ensured supervision should not be allowed to perform the cleaning and maintenance of equipment.
- Additional precautions should be taken when using this device in the presence of children or pets. Do not allow. children to play with the device. Never use the product close to combustibles.
- Never expose the product to atmospheric conditions such as direct sun light or rain, etc… Never use the product in humid conditions (like bathroom or camping house).
- Only Original accessories should be used, as well as accessories recommended by the manufacturer. Using accessories which are not recommended by the manufacturer may result in damage of the device and may render the device unsafe for use.
- The AC adapter should be connected to an outlet with characteristics consistent with the values on the rating label.
- If the cord or power plug or adaptor is damaged or the plug has a loose electrical outlet, do not charge the device and do not power it from the mains.
- Unplug the AC adapter from the electrical outlet when not in use.
- Do not connect or disconnect the adaptor from the power source with wet hands.
- Having disconnected the appliance from the power supply, clean it under running water no warmer than 50 degrees.
- Only a wireless appliance may be used in the bath or shower.
- Do not use the shaver if the film or blades are damaged in any way.
- Do not use the appliance if the blades or any element of the trimming head is damaged.
- The appliance may be charged in temperatures in the range of 5-35 degrees Celsius.
- For reasons of hygiene, the appliance should be used by one person only.
- Cutting head
- Power switch
- Comb caps (2,2,5, 3 mm)
- Charging socket
- Cleaning brush
- General-purpose lubricating oil
CHARGING THE DEVICE
If the device has a low battery or has been completely discharged, it is
necessary to connect the device to the charger. To do this, insert the charger
plug into the device, then connect the charger to the mains.
After connecting to charging, the LED next to the USB-C port will start
flashing red, informing about the charging process. When the device is fully
charged, the LED will turn green.
After connecting the device to the charger, you can continue cutting; however,
do not use the device near bathtubs, showers, swimming pools and similar wet
areas.
USING THE HAIR CLIPPER
Choose the appropriate comb cap (the hair length mark after the cut is visible
on the side of the comb cap). Install the comb cap on the hair clipper.
Turn on the hair clipper with the power switch. Slowly move the device over
your hair.
It is recommended to direct it “against the grain”, in the direction opposite
to hair growth.
Note: Take care to remove excess cut hair from the comb cap. After
cutting, remove all hair from the cutting head.
CLEANING THE HAIR CLIPPER
Before use make sure that the device is turned off and disconnected from the
charger.
Clean the comb caps under running water.
Sweep the blades with a brush.
The cutting head can be cleaned under running water.
It is recommended to apply a little general-purpose lubricating oil to the
cleaned blades.
Device is compliant with EU directives:
Electromagnetic compatibility (EMC) Device marked CE mark on rating label
When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2012/19/EU. Please inform yourself about the local separate collection system for electrical and electronic products. Used appliance should be delivered to the dedicated collecting points due to hazardous components, which may affect the environment. Do not dispose this appliance in the common waste bin.
Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be dispose with normal household waste. Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health.
Environmental information
All unnecessary packaging has been omitted. We have tried to make the
packaging easy to separate into three materials: cardboard (box), polystyrene
foam (buffer) and poly ethylene (bags, protective foam sheet).
Your system consists of material which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations. regarding the disposal of packaging materials, exhausted batteries and old equipment.
TECHNICAL SPECIFICATIONS OF THE APPLIANCE
Voltage: 3.7V
Max. input current: 2000mA
Competence Center
2N-Everpol Sp. z 0.0.
ul. Puławska 403A
02-801 Warsaw, Poland
phone: +48 22 688 08.00
e-mail: info@everpol.pl
www.blaupunkt.com
W przypadku pytań lub problemów prosimy o kontakt z naszym serwisem. In case
of questions or problems please contact our service.
Tel. 00 48 22 688 08 33
Email:tools@blaupunkt.pl
Wszelkie prawa zastrzeżone. Wszystkie nazwy marek są zarejestrowanymi znakami towarowymi należącymi do odpowiednich podmiotów. Dane i parametry techniczne mogą ulec zmianie bez wcześniejszego uprzedzenia.
All rights reserved. All brand names are registered trademarks of their respective owners. Specifications are subject to change without prior notice.
