BLAUPUNKT MPS 1652 TY Velocity Power Toyota Plug and Play 2-Way Coaxial Speaker Instruction Manual
- October 27, 2023
- Blaupunkt
Table of Contents
BLAUPUNKT MPS 1652 TY Velocity Power Toyota Plug and Play 2-Way Coaxial
Speaker
INTRODUCTION
Proper system planning is vital in order to maximize the device’s performance and road safety. Plan your installation carefully to avoid compromising performance re-liability of the system. Consult an authorized Blaupunkt dealer for installation or reparation. Read the manual carefully before operating the device for the first time.
Safety Notes
Ensure to follow below safety notes during installation and wiring connection:
–
- Disconnect the negative terminal of the battery. Refer to the safety notes of the vehicle manufacturer.
- Ensure positions of the holes are nowhere near the vehicle component to avoid any damage during drilling.
- Ensure cross section of the cable is no less than 2.5mm2 if the positive and negative cables are too long.
- Incorrect installation may result in malfunction of the device or the car sound system.
Installation and Connection Instructions
- Select a dry and well-ventilated location to install the device.
- The device must not be installed in overly exposed location such on therein shelf, rear seat etc.
- The installation location must be suitable for screw holes and have stable ground support.
Disclaimer
In no event shall Blaupunkt be liable for any direct, indirect, punitive,
incidental, special consequential damages to property or life and whatsoever
arising out of or connected with the use or misuse of our products.
USA & CANADA: This product is not intended for sale in the United States and Canada. If purchased in the U.S. or Canada, this product is purchased on as-is basis. No warranty, whether expressed or implied is provided in the U.S. or Canada.
Voltage Supply
- Use the supplied power extension cable to connect to the positive battery terminal.
- Firmly and carefully connect the ground lead to a bare metal point on the vehicle chassis.
- The control of the device should be a two-channel control, either via the preamplifier output of the car sound system.
- A control solely via the right or left channel is also possible since the low-frequency portion of the music is generally identical on both channels.
Recycling and Disposal
Do not dispose of your old unit in the household trash!
Use the return and collection systems available to dispose of the old device.
This manual may be updated from time to time without any notice.
SPECIFICATION
Pair of
6.5” Toyota plug & play 2-way coaxial speaker to upgrade OE speaker for
selected models with Polypropylene Cone including mounting hardware
- Max. Power Handling : 130W
- Normal Output Power (RMS) : 40W Voice Coil : 25mm
- Tweeter Size : 41.5mm
- Impedence : 4ohms
- Frequency Response : 2,000Hz – 20,000Hz Sensitivity : 90±3dB
- Mounting Depth : 48.5mm
- Mounting Hole Diameter : 133mm
INSTALLATION
TROUBLESHOOTING
If any of the following problem occur, please resort to Troubleshooting for the possible solutions. Consult Blaupunkt authorized dealer if problem persist.
| Problems | Possible Causes | Solutions |
|---|---|---|
| Speaker does not work | Incorrect or loose wiring connection. | Ensure proper |
wiring connections of speaker.
Fraying or broken cables.| Repair or replace if the cables are damaged.
Speaker is damaged.| Replace with a new speaker.
Distorted and hissing sound| Voice coil or speaker cone is damaged.| Replace
with a new speaker.
COMPATIBILITY LIST
MPS 1652 TY can be installed in the following list of car models :
Designed and engineered by Blaupunkt Competence Centre
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>