HD Ridez WB-FR312BD Overland Slider Drop Steps Installation Guide
- June 1, 2024
- HD Ridez
Table of Contents
HD Ridez WB-FR312BD Overland Slider Drop Steps
PARTS LIST
| 1 | Driver/Left Tube | 8 | 10mm x 27mm OD x 3mm Flat Washers |
|---|---|---|---|
| 1 | Passenger/Right Tube | 16 | 10mm x 20mm OD x 2mm Flat Washers |
| 2 | Drop Steps | 8 | 10mm Lock Washers |
| 1 | Driver/Left Front Mounting Bracket | 8 | 10mm Nylon Lock Nuts |
| 1 | Passenger/Right Front Mounting Bracket | 4 | 8mm Triangle Double Bolt Plates |
| 1 | Driver/Left Rear Mounting Bracket | 8 | 8mm x 22mm OD x 2mm Flat Washers |
| 1 | Passenger/Right Rear Mounting Bracket | 8 | 8mm Nylon Lock Nuts |
| 16 | 10mm x 30mm Hex Bolts |
PROCEDURE
- REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
- Starting from underneath the Passenger/Right body panel, locate the front mounting location and the threaded holes in the body panel, (Figure 1). Remove the plastic plugs covering the holes.
- Select the Passenger/Right Front Mounting Bracket. Attach the Mounting Bracket to the front location with (2) 10mm Hex Bolts, (2) 10mm Lock Washers and (2) 10mm Flat Washers, (Figure 2). Do not tighten hardware.
- Repeat Steps 2 & 4 to attach (1) Rear Mounting Bracket to the rear location, (Figures 3 & 4). Do not tighten hardware.
- Select the Passenger/Right Tube. Insert (2) 8mm Triangle Double Bolt Plates into the front (2) sets of (2) holes, (Figure 5). Attach (1) Drop Step to the (2) Double Bolt Plates with (4) 8mm x 22mm Flat Washers and (4) 8mm Nylon Lock Nuts, (Figure 6). Do not tighten hardware.
- With assistance, line up the mounting tabs in the Passenger/Right Tube to the rear faces of the Mounting Brackets. Secure the Tube to the Mounting Brackets with (4) 10mm Hex Bolts, (8) 10mm x 20mm Flat Washers and (4) 10mm Nylon Lock Nuts, (Figure 7). Do not tighten hardware.
- Level and adjust the Overland Step, then tighten all hardware.
- Repeat Steps 1—7to attach the Driver/Left Overland Step.
- Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used to clean the Overland Sliders.
Passenger/Right side Installation Pictured
(Fig 1) Passenger/Right front mounting location
Fig 2) Attach the Passenger/Right Front Mounting Bracket to the front location
(Fig 3) Rear mounting location (Driver/Left side shown)
(Fig 4) Attach (1) Passenger/Right Rear Mounting Bracket to the rear location
(Fig 5) Insert (1) Triangle Bolt Plate into the holes in the Tube
(Fig 6) Attach (1) Drop Step to (2) Bolt Plates
(Fig 7) Attach the Passenger/Right Overland Slider to the Mounting Brackets
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>