HD Ridez WB-CD171BD Steel Drop Down Boards Installation Guide
- June 1, 2024
- HD Ridez
Table of Contents
HD Ridez WB-CD171BD Steel Drop Down Boards
PARTS LIST
| 1 | Driver/Left DS4 Running Board | 32 | 10mm x 20mm OD x 2mm Flat Washers |
|---|---|---|---|
| 1 | Passenger/Right DS4 Running Board | 16 | 10mm Nylon Lock Nuts |
| 4 | Driver/Left Mounting Brackets | 16 | 8mm x 30mm Hex Bolts |
| 4 | Passenger/Right Mounting Brackets | 16 | 8mm Lock Washers |
| 16 | 10mm x 30mm Hex Bolts | 16 | 8mm x 24mm OD x 2mm Flat Washers |
PROCEDURE
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.
-
Start the installation under the Passenger/Right side of the vehicle.
a. For “Early” 2019 models, locate the 6 plugs along the bottom edge of the body. Mounting Brackets will bolt to the 1st, 3rd, 4th and 6th threaded mounting holes, (Figure 1).
b. For “Late” 2019 models, all (4) mounting locations will be used. -
Remove the plastic plugs from the Passenger/Right front mounting location. Select (1) Passenger/Right Mounting Bracket. Attach the Mounting Bracket to the factory threaded holes with (2) 8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Figures 2 & 3). Do not tighten hardware.
-
Repeat Steps 1 & 2 to attach the remaining (3) Passenger/Right Mounting Brackets to the (3) remaining locations along the rocker panel, (Figures 4—7). Do not tighten hardware.
-
Select the Passenger/Right DS4 Running Board. Attach the Running Board to the rear faces of the Mounting Brackets with (8) 10mm Hex Bolts, (16) 10mm Flat Washer and (8) 10mm Nylon Lock Nuts, (Figure 8). Do not tighten hardware.
-
Level and adjust the Running Board and fully tighten all hardware.
-
Repeat Steps 1—5 to attach the Driver/Left DS4 Running Board.
-
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used also to clean the Running Boards.
Passenger/Right side Installation Pictured
(Fig 1) Passenger/Right “Early” rocker panel mounting locations (arrows) NOTE:
Hold Bracket up to body panel to help determine the correct mounting
locations.
(Fig 2) Remove plastic plugs to uncover threaded inserts
(Fig 3) Attach (1) Passenger/Right Mounting Bracket to the mounting location
(Fig 4) Passenger/Right front mounting location
(Fig 5) Passenger/Right 2nd mounting location
(Fig 6) Passenger/Right 3rd mounting location
(Fig 7) Passenger/Right rear mounting location
Fig 8) Attach Passenger/Right DS4 Running Board to the Mounting Brackets
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>