PERLESMITH PSTVS33 Universal Swivel TV Stand Instruction Manual
- June 1, 2024
- Perlesmith
Table of Contents
PERLESMITH PSTVS33 Universal Swivel TV Stand
BEFORE GETTING STARTED
BEFORE GETTING STARTED, LET’S MAKE SURE THIS STAND IS COMPATIBLE
Check VESA Pattern Compatibility
Compatible VESA Pattern:
- 100 x 100mm
- 200 x 300mm
- 400 x 300mm
- 100 x 200mm
- 300 x 200mm
- 400 x 400mm
- 200 x 100mm
- 300 x 300mm
- 200 x 200mm
- 400 x 200mm
Maximum/Minimum:
- 400mm x 400mm [15.7″ x 15.7″]
- 100mm x 100mm [3.9″ x 3.9″]
If this stand is not compatible, please contact product support.
Check Max Load
WARNING
DO NOT exceed the maximum load. Exceeding the maximum load can cause the mount
to fail, leading to personal injury and/or property damage.
If your TV weighs more, this stand is NOT compatible.
Tools Needed [not included]
Important Safety Information
CAUTION: Avoid the risk of personal injury and property damage!
- Please carefully read all instructions before attempting installation. If you do not understand the instructions or if you have any questions or concerns, please call technical support or email customer service.
- This product contains small parts that may pose a choking hazard.
- Do not use this product for any purpose that is NOT explicitly specified in this manual. Do not exceed the maximum weight capacity. We are not liable for damage or injury caused by incorrect assembly, improper mounting, or inappropriate use.
- Before starting assembly, verify all parts are included and undamaged. Do not use damaged or defective parts. If you require replacement parts, please call technical support or email customer service.
- WARNING: All fasteners must be firmly tightened!
SAVE THESE INSTRUCTIONS.
Supplied Parts and Hardware
- 1. TV Bracket
- 2. Tempered Glass Base
- 3. Support Pillar
- 4. Plastic Cover
- 5. Swivel Bracket
- 6. TV Plate
- 7. Foot Pad
- 8. Safety Lock
- 9. Cable Clip
- H1. Bolt
- H2. Bolt
- I. Bolt
- J1. Steel Washer
- J2. Plastic Washer
Supplied Parts and Hardware for Step 1
Not all hardware included in this package will be used.
Supplied Parts and Hardware for Step 2
Supplied Parts and Hardware for Step 3
Supplied Parts and Hardware for Step 4
Supplied Parts and Hardware for Step 5
INSTALLATION
Step 1 Attach the TV Brackets to Your TV
Select TV Bolts
Position the TV Brackets
Secure the TV Brackets
- For Flat-Back TV, go to Option A on page 07.
- For Bump, Curved TV, Recessed Holes, and Cables, go to Option Bon page 08.
WARNING:
- DO NOT turn the bolt past the bottom of the hole.
- If the bolt is too short, it may not adequately support the TV.
- If the bolt is too long, it could damage the TV.
- At least 4-5 turns into the threading is required.
- The depth of the bottom holes may be different from the top holes.
Option A
Option B
Step 2 Assemble the Base
- Attach foot pads [07] to the frosted side of the tempered glass base [02]. Tip: Leave a small gap between the edge of the base and the foot pads.
- Secure the support pillar [03] to the tempered glass base [02] using the plastic cover [04]. plastic washers [J2], steel washers [J 1]. and bolts [I].
Step 3 Secure the TV Plate to the Support Pillar
- Note: There are four height options. Choose the best height position for your TV before moving on to attach your TV plate [06] to the pillar.
- Connect the swivel bracket [05] to the front of the support pillar [03] using bolts [H 1], then attach the TV plate [06] using bolts [H2].
Note: The rounded side of the TV plate should face the pillar, while the top edge of the TV plate should face the front of the stand.
Step 4 Hang the TV on the TV Plate
-
The TV brackets have two sets of hooks. Choose the appropriate hooks before hanging your TV. The #1 hooks will position your TV lower. The #2 hooks will position your TV higher.
HEAVY! You may need assistance with this step.
Note: Hang the TV on the center of the TV plate.
-
Insert the safety locks [08] into the upward-facing hooks located directly below the horizontal TV plate. Tighten the bolts until they secure against the bottom of the TV plate.
Step 5 Cable Management
Step 6 Swivel Adjustment
If necessary, the TV can be swiveled left or right. Only swivel the TV by
gripping the TV edges. Do not press on the screen.
MAGNIFY YOUR AUDIO-VISUAL EXPERIENCE
Contact Information
- 1-800-556-6806 (US/CA] Mon-Fri Barn – 8 pm (CST)
- 44-808-196-3891 (UK] Mon-Fri 2 pm – 10 pm (UTC)
- supportus@perlesmith.com
- www.perlesmith.com.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>