UBIQUITI UDW Dream Wall Instruction Manual
- June 1, 2024
- UBIQUITI
Table of Contents
UBIQUITI UDW Dream Wall
Product Information
- Assembly Instructions
- This document provides a step-by-step guide to assembling a product. Each step is represented by a clear diagram with accompanying instructions.
- Step 1
- Insert the tabs of part A into the slots of part B as shown in the diagram.
- Ensure that the parts click into place, indicating a secure fit.
- Step 2
- Attach part C to the assembly from Step 1, aligning it with the pre-drilled holes.
- Use the provided screws to fasten part C in place, tightening them with the included Allen key.
- Step 3
- Slide part D into the tracks on the sides of the assembly.
- Push part D until it is flush with the rest of the assembly.
- Step 4
- Connect the wires from part E to the corresponding connectors on part F.
- Make sure the colours of the wires match the colours of the connectors.
- Step 5
- Place part G onto the top of the assembly, aligning it with the outline.
- Press down firmly until part G snaps into place.
- Step 6
- Insert the power plug into the socket located on the back of the assembly.
- Ensure the plug is fully inserted and secure.
- Step 7
- Mount the assembly onto the wall bracket, making sure the hooks on the bracket fit into the slots on the assembly.
- Slide the assembly down to lock it in place on the bracket.
- Step 8
- Turn on the power switch to test the assembly.
- Check all functions to ensure proper operation.
Specifications
| Component | Description | Quantity |
|---|---|---|
| Part A | Base component with tabs | 1 |
| Part B | Receiving component with slots | 1 |
| Part C | Securing component | 1 |
| Part D | Sliding component | 1 |
| Part E | Wiring harness | 1 |
| Part F | Connector component | 1 |
| Part G | Top cover | 1 |
| Allen Key | Tool for screwing | 1 |
| Screws | Fasteners for assembly | 4 |
| Wall Bracket | Support for wall mounting | 1 |
| Power Plug | For electrical connection | 1 |
FAQs
What should I do if the parts don't snap into place?
Ensure that you have aligned the parts correctly as per the diagrams. If the issue persists, check for any obstructions or damage to the tabs and slots.
Can I use a power drill to fasten the screws?
It's advisable to use the provided Allen key to avoid over-tightening and damaging the parts.
What if the wires don't fit into the connectors?
Double-check that the colours of the wires match the colours of the connectors. If they do and still don't fit, contact customer support for assistance.
What should I do if the assembly does not function after powering it on?
Review all steps to ensure all connections are secure. Check the power source and ensure the switch is in the ON position. If the problem continues, consult the troubleshooting guide or contact customer support.
What if the wires don't fit into the connectors?
Double-check that the colours of the wires match the colours of the connectors. If they do and still don't fit, contact customer support for assistance.
WHAT IN BOX
TOOL REQUIRED
DIMENSION
INSTALLATION
Insert Card
CONNECTION
you need further assistance, visit our [Help Center](https://help.ui.com/hc
/en-us/categories/6583256751383) or contact Ubiquiti Support.