ADLER AD 1119 Transient Radio User Manual
- June 1, 2024
- ADLER
Table of Contents
ADLER AD 1119 Transient Radio
SAFETY CONDITIONS
IMPORTANT INSTRUCTIONS ON SAFETY OF USE PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
The warranty conditions are different, if the device is used for commercial purpose.
-
Before using the product please read carefully and always comply with the following instructions. The manufacturer is not responsible for any damages due to any misuse.
-
The product is only to be used indoors. Do not use the product for any purpose that is not compatible with its application.
-
The applicable voltage is 230V ~50Hz. For safety reasons it is not appropriate to connect multiple devices to one power outlet.
-
Please be cautious when using around children. Do not let the children to play with the product. Do not let children or people who do not know the device to use it without supervision.
-
WARNING: This device may be used by children over 8 years of age and persons with reduced physical, sensory or mental capabilities, or persons without experience or knowledge of the device, only under the supervision of a person responsible for their safety, or if they were instructed on the safe use of the device and are aware of the dangers associated with its operation. Children should not play with the device.
Cleaning and maintenance of the device should not be carried out by children, unless they are over 8 years of age and these activities are carried out under supervision. -
After you are finished using the product always remember to gently remove the plug from the power outlet holding the outlet with your hand. Never pull the power cable!!!
-
Never leave the product connected to the power source without supervision. Even when use is interrupted for a short time, turn it off from the network, unplug the power.
-
Never put the power cable, the plug or the whole device into the water. Never expose the product to the atmospheric conditions such as direct sunlight or rain, etc.. Never use the product in humid conditions.
-
Periodically check the power cable condition. If the power cable is damaged the product should be turned to a professional service location to b e replaced in order to avoid hazardous situations.
-
Never use the product with a damaged power cable or if it was dropped or damaged in any other way or if it does not work properly. Do not try to repair the defected product yourself because it can lead to electric shock. Always turn the damaged device to a professional service location in order to repair it. All the repairs can be done only by authorized service professionals. The repair that was done incorrectly can cause hazardous situations for the user.
-
Never put the product on or close to the hot or warm surfaces or the kitchen appliances like the electric oven or gas burner.
-
Never use the product close to combustibles.
-
Do not let cord hang over edge of counter.
-
Do not immerse the motor unit in water.
-
The device must be used and stored in a dry place only.
-
Do not allow to come into contact with water. If the device gets wet, disconnect the plug from the mains socket with dry hands. Then bring the device to a service facility for a check or repair.
-
Do not place any objects on the device.
-
Make sure that vents are always uncovered. An obstructed vent may cause damage to the device or even a fire.
-
Do not place open flame or heat sources on the device or in the vicinity.
-
If you are not going to use the device for a period longer than one week, do not leave batteries inside.
Overview
- antenna
- Tuning knob
- FM/ AM band switch
- Headphone socket
- On/Off switch and volume control knob
- Power cable socket
- Battery cover
Listening To The Radio
Open the battery cover (7) on the back of the radio. Slide the cover down in the direction pointed by the arrows embossed on the cover. If needed, place 4 LR14 batteries inside, according to polarity on the casing. Close the battery cover. Place the power cable plug in the socket (6) and in the mains socket. Pull out the telescopic antenna (1). Turn on the radio by turning the volume control knob (5) to the right. Set the band with the switch (3). Select a radio station with the tuning knob (2). Headphones may be connected to the socket (4). You can switch on on the radio by turning the knob (5) to the left.
TECHNICAL DATA
Voltage: 230V~50Hz & LR14
Power: 6,00W AM 522-1620 kHz
FM 87.5-108 MHz
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins. Used appliance should be delivered to the dedicated collecting points due to hazardous components, which may effect the environment. Do not dispose this appliance in the common waste bin.
Simplified EU Declaration Of Conformity
Adler Sp. z o.o., Ordona 2a, 01-237 Warsaw, Poland hereby declares that the
AD1119 device complies with Directive 2014/53 / EU. The full text of the EU
declaration of conformity is available at the following internet address:
https://www.adler.com.pl/dane/deklaracje/CE/ad_1119.pdf
CUSTOMER SUPPORT
Hereby, Adler Sp. z o.o., Ordona 2a, 01-237 Warsaw, Poland declares that the
radio equipment type Radio CR1140 is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the
following internet
address :https://www.adler.com.pl/dane/deklaracje/CE/
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>