BLAUPUNKT 150 Beverly Hills Bluetooth Radio Receiver User Manual
- June 1, 2024
- Blaupunkt
Table of Contents
BLAUPUNKT 150 Beverly Hills Bluetooth Radio Receiver
IMPORTANT NOTICE& PRECAUTIONS
Thank you for using our company multimedia player. To operate the unit correctly. please read the operation manual carefully before using . Keep this operation manual for further reference. The unit is designed only for DC 12V negative ground operation system. Make sure your vehicle is connected to DC 12V negative ground electrical system. Be sure to connect the speaker(-)leads to the speaker(-) terminal. Never connect the left and right channel speaker wires together or to the vehicle body. The normal temperature for operation is between-20 and +60 degree Celsius. Do not work in extreme high or low temperature and block vents radiator panels of the unit ,bocking them will cause heat to build up inside the unit and may cause damage or fire. This unit can play the following discs(12 cm)and media files: DVD/MP3/WMA/CDR/RW/ JPEG
INSTALLATION
Accessories included in the acka e for installation
Mounting Method B
Diagrama De Conexin
Main Unit Operation
PAUSE/PLAY/KEY NUMBER 1
-
USB/SD Mode:
Press the pause/Play bytton to pause, play, or resume audio playback. Turning the volume knob will also resume playback. -
In Radio Mode:
Press to select the preset stations assigned to key number 1. -
BROWSE/KEY NUMBER 2 USB/SD Mode:
Press the browser button to play 10 seconds clip of each song. -
Radio Mode:
Press to selct the preset station assignet to the key nuber 2. -
REPEAT/KEY NUMBER 3 USB/SD Mode:
Press the repeat button to repeat a single song. Press repeatedly to toggle through repeat options. -
RAM DOM PLAY/KEY NUMBER 4 USB/SD Mode:
Press the random play button to shuffle through tracks -
In Radio Mode:
Press to select the preset station assigned to Key Number 4. -
D-/KEY NUMBER 5
USB/SD ModePress the D-button to display the previous folder (if available) -
In Radio Mode
Press to select the preset station assigned to Key Number 5 -
D+/KEY NUMBER 6
USB/SD ModePress the D+ button to display the previous folder (if available) -
In Radio Mode:
Press to select the preset station assigned to Key Number 5. -
MODE:
Press the MODE button to cycle between RADIO/USB/SD/AUX/BT modin Bluetooth(BT) mode, The MODE Key is used to end a call.
Note : Depends on different type of discs and media files that recorded, not all operations as described in the above operation manual can be functioned.
REMOTE HANDSET – GENERAL OPERATION
BATTERY REPLACEMENT
Refer to the back of remote handset for details on how to replace the
batteries.
NOTES
- Attention should be drawn to the environmental aspects of battery disposal.
- Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
- Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
BLUETOOTH PRING
- Enable Bluetooth on your device
- Scan for available devices.
- Select “BEVERLY HILLS 150” or a similar name, when it appearsn your device.
- Enter the code when prompted: 0000.
Disconnection with Mobile Phone
To disconnect the Bluetooth connection with the mobile phone, press & hold
shortly” A or EJ” on the main unit, ” BT OFF”will appear shortly on LCD
display of the main unit when the linked-up disconnected.
APPLICATION TO CONTROL THE UNIT VIA BLUETOOTH OF MOBILE PHONE
User can download the following application to the mobile phone in order to
have control of the main unit by the mobile phone via Bluetooth. Take your
phone and follow the steps:
- The following menu appeared in the mobile phone and you can start control the car unit with this menu (Bluetooth must be connected):
SPECIFICATION
GENERAL
- Power Requirement: DC 12 Volts, negative ground
- Load Impedance: 4 Ohms
- Maximum Power Output: 30 watts x 4 (RMS)
- Tone Control – Bass (at 100 Hz) +/- 8 dB
- Treble (at 10 KHz) +/- 8 dB
FM RADIO SECTION
- Frequency Range
- -FM: 87.5-107.9 MHZ
- -AM: 530-1710 KHz
- Storage Number:
- -FM: 18 Radio Stations
- -AM; 12 Radio Stations
- Search Method: Manual / Auto
DISC SECTION
- Disc Play: DVD / VCD / MP3 / CD
- Mounting Angle: +/- 30 degree
VIDEO & TV SECTION
- Video System: NTSC
- Video Output Level: 1.0Vp-p 75 Ohms
- Horizontal Resolution: 500
- TV System: NTSC / PAL / SECAM
BLUETOOTH SECTION
- Communication type: V4.0
- Maximum Distance: 5 meters
AUDIO SECTION
- Maximum Output Level: 2 Vrms (+/-3 dB)
- Frequency Response: 20 Hz to 20 KHz
- Signal to Noise Ratio: 85 dB
- Channel Separation: 80 dB
Note : Specification and design; functions and features; unit illumination; colour and display segment are subject to change without prior notice. Photos and drawings on gift box or operation manual might be varied from the exact unit. Depends on the input devices, operation might be varied from the operation manual described.
SIMPLE TROUBLE SHOOTING
PROBLEMS, CAUSES & SOLUTIONS
No power
- Check and make sure the connecting wires are connected correctly
- Check whether the fuse is blown. Replace with the proper value fuse if necessary.
No sound
- Check and make sure the speaker wires are connected correctly.
No picture
- Check whether the video wire is connected to the video device.
Unit hang-up
- Press the RESET button to reset the unit to its default stage.
No function when pressing the buttons
- Press the RESET button to reset the unit to its default stage.
Poor effect or unable to receive radio
- Check whether the radio antenna is inserted or properly connected.
- Antenna may not be the proper length. Make sure the antenna is fully extended.
- Antenna may be poorly grounded. Check and make sure the antenna is properly grounded.
Stereo cannot be received under radio mode
- Tune the radio frequency accurately.
- The broadcasting signal is too weak, set the mode to MONO.
Disc inserted but cannot play
- Check whether the disc inserted upside down.
- Check whether the disc is dirty or badly cracked.
- Lens is dirty. Clean lens by using the lens clean disc.
Abnormal moving, skipping or sound during playback
- The disc is dirty or damaged. Wipe the disc with a dry soft cloth or replace a new disc.
Remote handset does not work
- Replace new battery of the remote handset.
- Point the remote handset directly at the remote sensor of the main unit.
- Clean the surface of the remote sensor.
Bluetooth not operated
- check the devices are linked up correctly.
Note: After the above efforts, if the unit still cannot be worked normally, consult your service dealer. Never attempt to disassemble the unit by yourself. No service part inside the unit.