Ziel Home LBT020 RGB LED Controller Instructions
- June 1, 2024
- Ziel Home
Table of Contents
Ziel Home LBT020 RGB LED Controller Instructions
- Power onloff-Press and hold the power button.
- Change the mode: Short press the cycle button.(Multiple mode options: Static Red/Static Green/Static Blue/Static White/Multicolour Change/Multicolor Flash/Multicolour Breathing/White Breathing/Red Breathing/Green Breathing/Blue Breathing)
- Adjust the flashing speed: Short press the power button.
- Adjust the brightness Press and hold the cycle button and short press the power button meanwhile.
Remote control instructions
NOTE
- During use, if the switch can work normally, but the remote control cannot, you need to perform the code matching operation.
- if the light is interfered by other remote controls or cannot be controlled remotely. Please power off and then power on again before performing code matching. How to perform code matching operation: Press and hold the start button on the remote control for 3 seconds within 7seconds of turning on the power, the light strip flashes 3 times with white light, indicating that the code (remote control) is matched.
FCC ID: 2A9H8-LBT020
IC: 30943-LBT020
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
ISED Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference. (2) This device must accept any interference,
including interference that may cause undesired operation of the device. The
digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian information on RF exposure and compliance. This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment.
The device has been evaluated to meet general RF exposure requirement. This equipment should be installed and operated with minimum distance 0mm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>