Ziel Home Furnishing Technology Co Ltd LTV330 Light Strip Digital Device Instruction Manual

September 6, 2024
Ziel Home Furnishing Technology Co Ltd

LTV330 Light Strip Digital Device

“`html

Product Information

Specifications:

  • Model: [Insert Model Number]
  • Power Source: [Insert Power Source]
  • Operating Range: [Insert Operating Range]
  • Compliance: FCC Part 15

Product Usage Instructions

Switching Modes:

To switch modes, perform a short press on the cable.

Power On/Off:

To power on/off, perform a long press on the cable.

Code Matching Operation:

If the remote control is not working properly, you may need to
perform a code matching operation. Follow these steps:

  1. Press and hold the power button on the remote for 3 seconds
    within 7 seconds of turning on the power.

  2. The light strip will flash 3 times with white light, indicating
    successful code matching.

FCC Warning:

This device complies with part 15 of the FCC rules. Operation is
subject to the following conditions:

  1. The device may not cause harmful interference.
  2. The device must accept any interference received.

Radiation Exposure Statement:

The device has been evaluated to meet general RF exposure
requirements. It can be used in portable exposure conditions
without restriction.

FAQ

Q: What should I do if the light is interfered by other remote

controls?

A: Power off and then power on again before performing code
matching to resolve interference issues.

Q: How do I know if the code matching operation was

successful?

A: The light strip will flash three times with white light to
indicate successful code matching.

“`

INSTRUCTION
1.short press on cable to switch mode.
2.long press on cable to power on/off.
NOTE 1. During use, if the switch can work normally, but the remote control cannot, you need to perform the code matching operation. 2.if the light is interfered by other remote controls or cannot be controlled remotely. Please power off and then power on again before performing code matching.
How to perform code matching operation: Press and hold the power button on the remoter for 3 seconds within 7 seconds of turning on the power, the light strip flashes 3 times with white light, indicating that the code (remote control) is matched.

FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals