Ziel Home Furnishing Technology Co Ltd RMB912 Human Baby Sensing Light Strip User Manual
- July 5, 2024
- Ziel Home Furnishing Technology Co Ltd
Table of Contents
User manual
Human baby sensing light strip
Model: RMB912
RMB912 Human Baby Sensing Light Strip
You can use a switch or remote control to control the lighting effect
Short press on key: turn on the light -3000K-6000K- 4500K – turn off the light
(cycle)
Long press the power button: brightness+/brightness-
Remote control instructions
| NO/OFF
---|---
| Short press to increase brightness (8 gears), long press to dimming
infinitely
| Short press to decrease brightness (8 gears),
| Short press to adjust color temperature from 6000K to 3000K (8 gears), long
press to linearly adjust color temperature from 6000K to 3000K
| Short press to adjust color temperature from 3000K to 6000K (8 gears), long
press to linearly adjust color temperature from 3000K to 6000K
Notes
During use, if the switch can function normally but the remote control cannot
function properly, a code matching operation needs to be performed.
If the light is disturbed by other remote controls or cannot be remotely
controlled. Before executing code matching, please turn off the power before
turning it on.
How to perform code matching operation: Within 5 seconds of turning on the
power, press and hold the start button on the remote control for 3 seconds,
and the light strip will flash 3 times, indicating that the code (remote
control) matches.
FCC ID: 2A9H8-RMB912
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modi?cations to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>