DINAN D193-0937 Supplemental Ride Quality and Handling Kit Installation Guide
- June 9, 2024
- DINAN
Table of Contents
DINAN D193-0937 Supplemental Ride Quality and Handling Kit
D193-0937 HANDLING KIT; F56 Mini
INSTALLATION NOTES
Thank you for purchasing a Dinan Handling Kit. We have spent many hours
developing this kit to assure that you will receive maximum performance and
durability with minimum difficulty in installation. Please take the time to
read these instructions and contact us if you have any difficulties during the
installation.
This kit is intended to be used with a companion Dinan Spring Set, p/n
D100-0937.
This kit contains:
- (2) Front Bumpstops *
Please include these items when installing the Dinan spring set. The OE rear bumps tops are reused.
- Dinan’s bumpstops may include a plastic or rubber protective boot. Please remove the Dinan boot and reuse the OE boot whenever possible.
Alignment:
- An alignment is required after installation.
- Set tire pressures to factory recommended values.
- All Dinan suspension alignments are done with full fuel tanks and no weight inside the vehicle.
- Specifications are as follows:
FRONT:| Setting| Tolerance
---|---|---
Camber| -0.5°| ± 0.42°
Caster| 4.0°| ± 0.5°
Total Toe| 0.20°| ± 0.07°
REAR:| |
Camber| -1.9°| ± 0.08°
Total Toe| 0.23°| ± 0.07°
If you encounter any difficulties during the installation, or if these instructions are not clear to you, please call Dinan’s Technical Support Staff @ 800-341-5480.
Happy Motoring!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>