AIRTITANS 15423RX Remote Control Dinosaur Toy Instructions

AIRTITANS 15423RX Remote Control Dinosaur Toy

INSTRUCTION GUIDE

CONTROLLER (15423TX): x3 1.5V AAA (R03/LR03) BATTERIES REQUIRED ( NOT INCLUDED) JURASSIC WORLD MASSIVE ATTACK T-REX R/C (15423RX)

WITH NIMH (9.6V) RECHARGEABLE BATTERY & USB-C CHARGING CABLE (INCLUDED)

CHARGING THE AIR TITAN BASE

1. Insert SIDE A of charging cable into foot base of T-Rex.
2. Insert SIDE B into 5V USB Charger (NOT INCLUDED.)
3.  The charging cable also works with a computer USB port (NOT INCLUDED.)
4. Charge until the red LED light stops flashing and is solid.

CONTROLLER BATTaERY INSTALLATION

ADULT INSTALLATION REQUIRED

1. Locate the battery compartment on the bottom of the R/C Controller.
2.  Using a Phillips Head Screwdriver (not included), remove the screw and battery door.
3.  Controller – Install 3 new “AAA” (R03/LR03) batteries.
4. Replace the battery door and the screw.

CONTROLLER FUNCTIONS

TANK STEERING

R/C PAIRING

BASIC OPERATION

• Move ON/OFF switch on RC CONTROLLER to the ON position.
• Press-IN POWER BUTTON on AIRTITAN base.
• Place the AIRTITAN on the floor with wheels facing the ground.
•  AIRTITAN will automatically begin to animate, roar, and inflate as soon as both CONTROLLER and BASE are turned on.
•  The LED light on the REMOTE CONTROL will flash when pairing with the AIRTITAN
• The pairing process is completed when the LED light is solid, then the AIRTITAN is ready to drive.
  NOTE: If the LED light on the REMOTE CONTROL is flashing; switch off both AIRTITAN and REMOTE CONTROL and repeat the pairing process.

CONTROLLER SHORTCUTS QUICK PLAY:

• To SKIP opening animation and sounds HOLD the ROAR and STOMP buttons on the controller immediately at startup for 3 seconds.

QUICK FAN ON/OFF:

• To quickly turn OFF the fan on the unit HOLD a single back button (ROAR or STOMP) for 5 seconds.

•  To quickly turn the fan back ON, HOLD a single back button (ROAR or STOMP) for 5 seconds.

• If the fan is OFF you must still manually turn off both the AIRTITAN BASE and CONTROLLER units.
  ATTACK MODE:

• To enable ATTACK MODE, hold the ROAR and STOMP buttons AFTER the AIRTITAN has fully inflated for 3 seconds.

• This will cause you to lose control of the AIRTITAN!
  IDLE MODE

• After the AIRTITAN is idle for over 2 minutes, it will enter sleep mode and deflate.

• Press the POWER BUTTON on the base OFF and then ON to reconnect and exit sleep mode.

TROUBLESHOOTING

AIRTITAN WON’T MOVE/ INFLATE

| 1.    AIRTITAN or CONTROLLER is switched OFF.

2.    AIRTITAN base needs to be charged.

3.    Weak CONTROLLER batteries.

4.    AIRTITAN is stuck.

5.    CONTROLLER is not close enough to AIRTITAN.

6.    Fabric tears.

| 1.  Move the switch to the ON position.

2.  Use provided USB-C CHARGING CABLE and charge your AIRTITAN until the LED stops blinking and is solid.

3.  Press any direction button while switched on. If the indicator light does not activate, replace batteries in the Controller.

4.  Move AIRTITAN to a smoother surface, clean wheels, and make sure the surface or floor is clean as well.

5.  Make sure the Controller is placed within the signal receiving range.

6. Patch fabric tear, or purchase new unit.

THE CONTROLLER ISN’T PAIRED/ DOESN’T WORK| 1. CONTROLLER needs to be paired again

2. CONTROLLER LED not on.

3. CONTROLLER sound not on.

| 1.   Move ON/OFF switch on RC CONTROLLER to the ON position and Press-IN POWER BUTTON on AIRTITAN base.

2.     Replace batteries.

3.   Turn the controller off and back on, if no sound persists replace CONTROLLER batteries.

SAFETY INFO

•  NEVER operate near traffic, buildings, trees, people or other obstructions.
•  NEVER operate during storms or other adverse weather conditions.
• ALWAYS point away from face, eyes, people, animals and property when operating.
•  ALWAYS use alkaline batteries.
•  NEVER use in water or mud.
• NEVER use near glass or other fragile objects.

BATTERY SAFETY INFORMATION:
WARNING! Battery acid leakage can cause personal injury and cause damage to the product and surrounding property. If battery leakage occurs, thoroughly wash any affected skin, making sure to keep battery acid away from eyes, ears, nose and mouth. Immediately wash any clothing or other surface that comes in contact with leaked battery acid. Leaking batteries may make “popping” sounds. Always remove replaceable batteries before disposing of the product. Dispose of batteries or products with non-replaceable batteries according to Local, State or Federal Battery and Recycling Laws.
TO AVOID BATTERY PROBLEMS:

• NEVER mix old and new batteries or different brands of batteries.
• NEVER mix alkaline, standard (carbon-zinc), rechargeable batteries with this product.
•  NEVER dispose of batteries in fire, as they may leak and explode.
• ALWAYS remove batteries when exhausted or unused for a long time.
•  ALWAYS have an adult install battery consistent with installation instructions. ONLY use batteries specified by the manufacturer.
•  Batteries are to be inserted with the correct polarity (+ and -).
•  The supply terminals are not to be short-circuited.
• Non-rechargeable batteries are not to be recharged.
•  Rechargeable batteries are to be removed from the toy before being charged. (For CONTROLLER only)
• Rechargeable batteries are only to be charged under adult supervision.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.  this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
   This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: this device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation.
   WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
   NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

WARNING: Not suitable for children under 36 months. Small Parts. Choking Hazard.

References

• Home - JAKKS Pacific, Inc.
• Warranty - JAKKS Pacific, Inc.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>