BBK 1509 Performance Full Length Headers Installation Guide
- June 1, 2024
- BBK
Table of Contents
BBK 1509 Performance Full Length Headers
Product Information
Specifications
- Manufacturer: BBK PERFORMANCE LLC
- Part Numbers: 1509, 1510, 1535, 1538, 1635, 1638, 1659, 1660, 1671, 1672, 1810, 1811 + more
- Installation Time: Approximately 30 Minutes
- Difficulty Level: Very Easy
- Made in: U.S.A.
Frequently Asked Questions
- Q: Do I need any special tools for installing the Short H-Pipe/X-Pipe?
- A: No special tools are required for installation.
- Q: How long does it take to install the Short H-Pipe/X-Pipe?
- A: The installation process typically takes about 30 minutes.
- Q: Is it necessary to use safety equipment during installation?
- A: Yes, it is important to use all appropriate safety equipment and gear while working on the vehicle or installing any BBK Performance products.
FOR USE WITH BBK PERFORMANCE FULL-LENGTH HEADERS
More Information
- SPECIAL TOOLS REQUIRED: No special tools required
- INSTALL TIME: Approximately 30 Minutes
- DIFFICULTY: Very Easy
Note
- It may be necessary to use some WD-40 to aid in removal of the stock midpipe.
- Due to the metal to rubber slide mount these units can be sticky.
IMPORTANT
- All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
- BBK Performance accepts no responsibility for injuries or damage caused by or during the installation of this product.
Using Instructions
FOLLOW THESE INSTRUCTIONS CAREFULLY TO ENSURE CORRECT FITMENT AND OPERATION
STEP 1
- After installing your new BBK full-length headers, you can now install the matching short H-Pipe/X-Pipe by simply bolting it in place of the old H-Pipe Assembly.
- It may be necessary to use some WD-40 to aid in removal of the stock midpipe.
- Due to the metal to rubber slide mount these units can be sticky.
STEP 2
- Using the washers and nuts supplied with your full lengths stud kit, mount the front H-Pipe/X- Pipe flanges to the header collectors
STEP 3
- Using the supplied hardware, bolt up the BBK H-Pipe/X-Pipe.
NOTE
- Be sure to add a small amount of anti-seize to the top thread of each oxygen sensor using the supplied anti-seize packet.
- As you thread the oxygen sensor back into the part the anti-seize will spread evenly throughout the threads.
STEP 4
- Reconnect the factory air tube if installing catalyst equipped pipes.
Contact
BBK PERFORMANCE LLC
- 3060 Performance Circle Deland, FL 32724
- MADE IN U.S.A.
- WWW.BBKPERFORMANCE.COM
- For any questions, email us: TECH@BBKPERFORMANCE.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>