GEARMAZ 88433 2.4GHz Radio Control RC Racing Car User Manual
- June 5, 2024
- GEARMAZ
Table of Contents
88433 2.4GHz Radio Control RC Racing Car
User Manual
88473/88513/88423/88433/88133/88413/88243/88123/88093/88383
88343/88313/88113/88103/88493/88333/88283/88073/88183/88303
L 2.4 GHz RADIO CONTROL VEHICLE ‘I :1 2
Contents
RC Vehicle (Vehicle) x 1
RC Transmitter (Transmitter) x 1
Instruction Manual x 1
Battery Requirement
- Vehicle: 6 x 1.5V “M” batteries
- Transmitter: 1 x 9V battery
Battery Precaution
- Alkaline batteries are recommended to be used
- Only batteries of the same or equivalent type as recommended are to be used
- Do not mix alkaline, standard or rechargeable batteries
- Do not mix old and new batteries or different types of batteries
- Non-rechargeable batteries are not to be charged
- If rechargeable batteries are to be used, they are only to be charged by adult
- Rechargeable batteries are to be removed from the product before they are charged
- Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions
- Remove all batteries from the Vehicle and Transmitter when not in use
- Exhausted batteries are to be removed from the product
- The supply terminals are not to be short-circuited
- Dispose of batteries properly. Do not dispose of the batteries in a fire — it may cause them to explode or leak causing injury or damage
- Battery installation and removal must only be done by an adult
Battery Installation
For Vehicle (Fig. 1 and Fig. 2)
- Switch OFF the power. (The position of ON/OFF switch on the chassis of the Vehicle varies from each model.)
- Unscrew the screw on the battery cover.
- Open the battery cover.
- Install 6 new 1.5V “AA” batteries with correct polarities (+/-) compartment. as shown inside the battery compartment.
- Close the battery cover
- Tighten the screw on the battery cover.
For Transmitter (Fig. 3 and Fig. 4)
- Switch OFF the power.
- Unscrew the screw on the battery cover.
- Open the battery cover.
- Install 1 new 9V battery with correct polarity (+/-) as shown inside the battery
- Close the battery cover.
- Tighten the screw on the battery cover.
To Match the signal of the Vehicle and Transmitter
- Make sure the Vehicle and Transmitter is installed with batteries.
- Switch ON the Vehicle.
- Push the forward stick and hold it in the forwarding position, and switch ON the Transmitter.
- The front wheels of the Vehicle will turn left and right, to show that the signal matching between the Vehicle and Transmitter is completed.
- To avoid interference to the signal matching process, please make sure there is no other 2.4GHz device operating in the same area during the process.
- If the Vehicle is matched with more than one Transmitter, or more than one Vehicle is matched with one Transmitter. Just repeat the matching procedures and make sure only one Vehicle and one Transmitter is switched ON in the signal matching process.
How to Play
- Switch ON the Vehicle.
- Use the Forward / Backward joystick (Fig.3) to drive the vehicle forward and backward.
- Use the Left / Right joystick (Fig.3) to control the Vehicle turning left or right.
- If the vehicle does not run in a straight line, adjust the Direction Adjustment on the vehicle chassis (Fig.1)
- Play on a smooth surface to have the optimum performance.
- Remember to switch OFF the power of the Vehicle and Transmitter after playing.
- The optimum control range is up to 35m outdoor.
Performance Tips
-
Do not drive on grass, dirt, sand, dust, carpet or go through water.
-
Do not drive in windy or rainy weather.
-
Avoid direct impact on the Vehicle with obstacles.
-
Switch OFF the power when not in use to prevent damage to the Vehicle and Transmitter due to leakage of electrolytes from batteries.
-
Remove all batteries from the Vehicle and Transmitter when not in use for a long period.
-
Keep fingers, hair, and loose clothing away from wheels.
-
The operating range can be affected by a variety of factors.
a) Low Voltage of batteries in Transmitter or Vehicle.
b) Interference from other items that emit radio frequency signals. -
Outdoor usage is recommended in order to get optimum control range.
-
Recommend to play the vehicle on a clean and smooth surface.
-
Clean the battery compartment to make sure it is free from dust to prevent poor contact of batteries.
Cautions
- Do not attempt to disassemble the Vehicle or Transmitter.
- Make sure the batteries are installed with correct polarities (+/-) as shown inside the battery compartment.
- Remove the package and take out all accessories before giving the Vehicle and Transmitter to the child to play.
FCC label compliance statement:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: 1. This device may not cause harmful
interference and 2. This device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
Warning:
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
RSS-210 Compliance Statement:
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science, and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference. (2) This device must accept any interference,
including interference that may cause undesired operation of the device.
Disposal of batteries
Batteries should not be disposed of in household waste. As the consumer, you
are legally obliged to return batteries containing harmful substances and all
other used batteries. You can hand in your old batteries at public collection
points in your area or wherever batteries are sold. You will find these
chemical abbreviations along with a crossed-out refuse bin on batteries
containing harmful substances:
Pb=Battery contains lead
Cd=Battery contains cadmium
Hg=Battery contains mercury
The packaging and instruction manual contains important information. Please
keep them for future reference.
Warning! Choking Hazard. Not suitable for children under the age of 3
years due to small parts. We reserve the right to improve/amend specifications
and colors without notice.
Warning! The Antenna of the vehicle and/or transmitter is/are not to be
inserted into socket outlets.
Frequency band: 2405 — 2475 MHz
Maximum radio frequency power transmitted: <0 dBm
The trademarks, copyrights and design rights in and associated with
Lamborghini, Lamborghini with Bull and Shield Device are used under license
from Automobili Lamborghini S.p.A.,Italy
Porsche, the Porsche shield and the distinctive design of Porsche cars are
trademarks and trade dress of Porsche AG. Permission granted. Licensed
Manufacturer: Kldztech Toys Manufacturing Limited.
THE BUGATTI LOGO AND BUGATTI WORDMARK ARE TRADEMARKS OF BUGATTI INTERNATIONAL
SA AND ARE USED UNDER LICENSE. KIDZTECH TOYS MANUFACTURING LIMITED.
Manufactured under license from McLaren Automotive Limited. The McLaren name
and logo are registered trademarks of McLaren.
Land Rover and the Land Rover Logo are trademarks owned and licensed by Jaguar
Land Rover Limited.
General Motors Trademarks used under license to Kidztech Toys Manufacturing
Ltd.
2019 CHEVROLET USED UNDR LICENSE
SHELBY and GT500gand GT ISORD’are registered trademarks of Carroll Shelby and
Carroll Shelby Licensing, Inc. (Shelby).
“Mercedes-Beni and the design of the enclosed product are subject to
intellectual property protection owned by Daimler AG. They are used by
Kictztech Toys Manufacturing Limited under license.
Ford Motor Company Trademarks and Trade Dress used under license to KidzTech
Toys Manufacturing Ltd.
Nissan Motor Co.. Ltd. trademarks. designs, copyrights, and/or other
intellectual property rights are used under license.
Conforms to the safety requirements of ASTM F963
KIDZTECH TOYS MANUFACTURING LTD.
Room 802, 8/F, Inter-Continental Plaza,
94 Granville Road, TST East, HK.
Tel: (852) 27218868
[email protected]
http://www.kidztech.net
Made in China