FANATEC V2 CSL Elite Pedals User Guide

June 4, 2024
FANATEC

FANATEC V2 CSL Elite Pedals User Guide
FANATEC V2 CSL Elite Pedals

IMPORTANT! Do not connect the Pedals via RJ12 and USB at the same time!
Inductions
Instruction QR Code

PACKAGE CONTENT

PACKAGE CONTENT
PACKAGE CONTENT

CONNECTIONS

CONNECTIONS
CONNECTIONS

HARD-MOUNT

HARD-MOUNT
Instruction QR Code

BRAKE TUNING OPTIONS

BRAKE TUNING
BRAKE TUNING
BRAKE TUNING
BRAKE TUNING

This device complies with part 15 of the FCC rules. The operation of this device is subject to the following two conditions:

  • This device may not cause harmful interference, and must accept any interference received, including interference that may cause undesired operation.
  • This device was not modified differently than described explicitly in this user manual.

NOTE: This device was tested and approved to the limitations for class B of digital devices according to part 15 of the FCC rules. This limitation should ensure an adequate protection against harmful interferences in residential areas. However, a warranty for the non-recurring of interferences is not assumed.

Do not modify the device differently than explicitly described in the product related user manual. Nevertheless, if you do modify the device differently than explicitly described in the product-related manual, you can be determined to stop the operation of the device.
Symbols
Symbols

  • Video Manual
    QR Code

  • Driver Download

  • Driver & Firmware Instruction Manual

SUPPORT

 
 

The product warranty is provided by Endor AG. Refer to the included warranty sheet as well as the terms & conditions of Endor AG on fanatec.com.

Manufactured and distributed by
ENDOR Logo

Fanatec® is a registered trademark of Endor AG Designed and developed by Endor AG in Germany

E.ON-Allee 3 – 84036 Landshut – Germany
EU: 00800 0 FANATEC or +49 (871) 9221 -122
US/CANADA: 011 800 0 FANATEC or +49 (871) 9221 -122
AUSTRALIA: 00800 0 FANATEC or +49 (871) 9221 -122
JAPAN: +81 306 7172 -719
Email: info.webshop@fanatec.com
Website: www.fanatec.comwww.endor.ag
Made in China

Imported by Endor America LLC
8200 Wilshire Blvd. Suite 200 – Beverly Hills CA 90211 – USA
Telephone: tel: +1 321-655-3524
Email: info.webshop@fanatec.com
Website: www.fanatec.comwww.endor.ag

This product meets the requirements of the Technical Regulations which limit the use of certain hazardous substances in electrical and electronic equipment.

QR Code

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals