Keychron Q3 Max Wireless Mechanical Keyboard User Manual
- June 1, 2024
- Keychron
Table of Contents
Keychron Q3 Max Wireless Mechanical Keyboard
Fully Assembled Version
Keyboard
- 1x Fully Assembled Keyboard
Including
- 1x Aluminum Case
- 1x PCB
- 1x PC Plate
- 1x Sound Absorbing Foam
- 1x IXPE Foam
- 1x PET Foam
- 1x Latex Bottom Pad
- 1x Bottom Case Acoustic Foam
- 1x Bottom Case PET Foam
- 16x Gaskets (12 Installed and 4 in the Box)
- 5 sets x Stabilizers
- 1 set x Keycaps (PBT Double-shot)
- 1 set x Switches
Cable
- 1x Type-C to Type-C Cable
- 1x Type-A to Type-C Adapter
- 1x Extension Adapter for Receiver
Receiver
- 1x Type-A 2.4 GHz Receiver
Tools
- 1x Keycap & Switch Puller
- 1x Screwdriver
- 1x Hex Key
Barebone Version
Keyboard Kit
- 1x Keyboard Kit (Without Keycaps & Switches)
Including
- 1x Aluminum Case
- 1x РСВ
- 1x PC Plate
- 1x Sound Absorbing Foam
- 1x IXPE Foam
- 1x PET Foam
- 1x Latex Bottom Pad
- 1x Bottom Case Acoustic Foam
- 1x Bottom Case PET Foam
- 16x Gaskets (12 Installed and 4 in the Box)
- 5 sets x Stabilizers
Cable
- 1x Type-C to Type-C Cable
- 1x Type-A to Type-C Adapter
- 1x Extension Adapter for Receiver
Receiver
- 1x Type-A 2.4 GHz Receiver
Tools
- 1x Keycap & Switch Puller
- 1x Screwdriver
- 1x Hex Key
Quick Start Guide
If you are a Windows user, please find the appropriate keycaps in the box,
then follow the instructions below to find and replace the following
keycaps.
-
Switch To The Right System
Please make sure the system toggle on the top left corner has been switched to the same system as your computer’s operating system.
-
Connect 2.4 GHz Receiver
Note: For the best wireless experience, we recommend using the extension adapter for receiver and putting the 2.4 GHz receiver somewhere on your desk close to your keyboard for a low rate of latency and fewer signal interferences. -
Connect Bluetooth
-
Connect Cable
The VIA Key Remapping Software
Please visit us via. app to use the online VIA software to remap the keys. If
the VIA cannot recognize your keyboard, please reach our support to get the
instruction.
- The online VIA software can only run on the latest version of Chrome, Edge, and Opera browsers yet.
- VIA only works when the keyboard is connected by wire to the computer.
The Layers
- There are four layers of key settings on the keyboard. Layer 0 and layer 1 are for the Mac system. Layer 2 and layer 3 are for the Windows system.
- If your system toggle is switched to Mac, then layer 0 will be activated.
- If your system toggle is switched to Windows, then layer 2 will be activated. Remember that if you are using it in Windows mode, please make changes to the layer 2 instead of the top layer (the layer 0). This is a common mistake people are making.
The Backlight
Adjust The Backlight Brightness
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>