loocam SB1 Water Leak Sensor User Guide
- June 1, 2024
- Loocam
Table of Contents
loocam SB1 Water Leak Sensor
What’s in the Box
-
Water Leak Sensor
-
Quick Start Guide
Product Introduction
How to Use?
Download and install Loocam APP
Scan the QR code below with your smartphone or search in the App Store or
Google Play to download Loocam app.
Add Devices
-
Connect WiFi to your phone.
-
Please follow the corresponding adding operation to add gateway to the App.
-
Enter the Gateway interface and select “Add Sensor”— “Water Leak Sensor”.
-
Unscrew the bottom housing of the water leak sensor (as shown in the picture) and power on the device after taking out the insulating sheet.
-
Press and hold the Reset Button for about 5 seconds until the red light flashes on the device and release it. Then press the button one more time and you will see the blue light flashes on the device. At this time, the device enters the pairing mode.
Important Notice: When replacing the battery, please use insulated tools to remove the battery. Do not use metal tools for prying the battery to avoid short-circuiting and damaging the motherboard.
Indicator Light Description
| Status | Color | Feature |
|---|---|---|
| Paring/Upgrading | Blue Light | Flash |
| Resting | Red Light | Flash |
Installation
You can place the product in the kitchen, basement, window and other scenes
that may be flooded. The installation location is as shown in the picture.
Installation location is for reference only, the specific usage location is
subject to user requirements.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This product can not use alone and need to work with Loocam Gateway.
CUSTOMER SUPPORT
Copyright 2023 © Loo cam Technology LLC, All rights reserved. Apple and App Store are trademarks of Apple Inc., registered in the U.S. and other countries. Google and Google Play are trademarks of Google Inc
loocare@loocam.com
www.loocam.com
Responsible Party: Ansjer Electronics Co., Ltd
Company name :Loocam Technology LLC
Address: 2205 Hutton Dr, Unit 100, Carrollton TX 75006
Tel: 657-223-3477
E-mail: lavenderl@loocam.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>