GOTRAX FLYKART Hoverfly Kart Seat User Guide

Hoverfly Kart Seat
User Guide

CONGRATULATIONS COMMANDER,

YOU HAVE OFFICIALLY ENTERED THE GOTRAX GALAXY!
IT’S LIGHT-YEARS EASIER TO EXPLORE THE GALAXY (AND BEYOND!) WHEN YOU PUT SAFETY FIRST AND KNOW HOW TO NAVIGATE YOUR GOTRAX FLYKART HOVERBOARD-TO-GO- KART ACCESSORY.
ALL COMMANDERS UNDER 18, PLEASE GET PARENTAL PERMISSION PRIOR TO ASSEMBLING OR OPERATING THE GOTRAX FLYKART. IMPORTANT INTERPLANETARY NOTICE:
ALL GOTRAX GALAXY COMMANDERS MUST READ THE GOTRAX FLYKART QUICK LAUNCH GALAXY GUIDE FOR DETAILED INSTRUCTIONS, SAFETY WARNINGS, AND OTHER IMPORTANT GALACTIC GUIDELINES,

MISSION PREAPATION

UNPACK
INSIDE YOUR GOTRAX FLYKART CONTAINER YOU WILL FIND THE BELOW SUPPLIES FOR YOUR MISSIION.
A. ALLEN KEYS
B. HEX WRENCHES (2 PCS)
C. GASKET
D. WASHERS (4 PCS)
E. M10 WASHERS (2 PCS)
F. M8 WASHERS (4 PCS)
G. M81S BOLTS (4 PCS)
H. HANDLEBARS WITH FASTENER SYSTEMS (2 PCS)
I. FLYKART SEAT
J. WHEEL FRAME
K. ELCRO STRAP (2 PCS)
L. M1050 BOLTS (2 PCS)REMOVE ANY SPACE PARTICLES AND DOUBLE-CHECK FOR ANY ACCIDENTAL DAMAGE TO YOUR GOTRAX FLYKART THAT MAY HAVE OCCURRED DURING INTERSTELLAR TRANSPORTATION.
BUILD UP
THIS GALACTIC MISSION REQUIRES ASSEMBLY, FOLLOW THE BELOW STEP-BY-STEP INSTRUCTIONS TO PROPERLY ASSEMBLE YOUR FLYKART AND PREPARE FOR A SAFE LIFTOFF,
WARNING: FAILURE TO PROPERLY ATTACH, TIGHTEN, AND SECURE ALL BOLTS, LOCKNUTS, SCREWS, AND FASTENERS WILL INCREASE THE RISK OF INJURY.
TRAX TIP:
MAKE SURE YOUR HOVERBOARD IS FULLY CHARGED AND READY FOR GALACTIC GO-KARTING BEFORE YOU BEGIN ASSEMBLY.
ATTACH THE HANDLEBARS
Attach the two handlebars (H) to the screw rods on either side of the Wheel Frame (J).

• Put two large washers (D) and one M8 washers(E)on M10*50 screw (L).
• Put the handlebars (H) on the screw rods, Both handlebars (H) should point towards the wheel with the arms of the handlebars (H) extending outwards.
• Use the M10*50 screw (L) on the screw hole and tighten until each handiebar(H) Is firmly secured on the screw holes.

SECURE THE SEAT
Attach the FLYKART seat (I) to the Wheel Frame (J) plate using the M8*15 bolts (G) and M8 Washers (F).

• Place the seat (D in position and insert the bolts (G) and M8 Washers so they go through both the seat (1) and the Wheel Frame (J) plate.

• Tighten the M8″15 blots (G) using the Allen key (A) and the hex key until the seat (I) is securely fastened to the wheel frame (J) plate.
  ADJUST THE WHEEL FRAME
  Attach the length of the Wheel Frame (J) to fit your height.

• Secure with the Gasket (C).

• Tighten the Gasket (C) until it is firmly secured.
  FASTEN THE FLYKART TO YOUR HOVERBOARD
  Use the velcro fastener straps to attach the FLYKART to your self*balancing scooter aka hoverboard.

• Make sure the hoverboard is facing the correct direction so that the FLYKART wheel will be in front.

TRAX TIP:
PLOT OUT YOUR ORBIT AFTER YOU HAVE ASSEMBLED YOUR GOTRAX FLYKART, CHECK FOR ANY SPACE OBJECTS AND POTENTIAL HAZARDS.
SUIT UP
STRAP ON YOUR SPACE HELMET, KNEE PADS, ELBOW PADS, AND GLOVES PRIOR TO BOARDING YOUR GOTRAX HOVERFLY KART.
SAFETY GEAR IS IMPORTANT FOR ALL COMMANDERS OF THE GOTRAX GALAXY.
ALWAYS WEAR RUBBER-SOLED ATHLETIC SHOES WITH LACES TIED AND OUT OF THE WAY.
BOARDING PROCEDURES

• FIND A WIDE-OPEN FLAT PLANETARY SURFACE THAT IS SAFE FOR GALACTIC GO-KARTING.
• SIT IN THE GOTRAX FLYKART SEAT.
• CHECK FOR ANY LOOSE OR HANGING ARTICLES OF CLOTHING THAT COULD INTERFERE WITH YOUR MISSION.

MISSION LAUNCH

• WHILE SEATED IN THE FLYKART, PRESS THE POWER BUTTON ON THE BACK OF YOUR HOVERBOARD TO TURN IT ON.
• FIRMLY HOLD ONTO THE HANDLEBARS WITH BOTH HANDS,

TRAX TIP:
WATCH OUT FOR PEOPLE, CARS, ALIENS, ASTEROID FIELDS, AND ANY OTHER SPACE PARTICLES.
GO-KARTING THROUGH THE GALAXY

• FORWARD ACCELERATION: GENTLY PUSH THE HANDLEBARS SLIGHTLY FORWARD TO ACCELERATE.
• SPEED CONTROL: THE HARDER YOU PUSH, PULL, OR TURN THE HANDLEBARS, THE FASTER YOU WILL GO.
• SLOW TO STOP: GENTLY PULL THE HANDLEBARS SLIGHTLY BACK TO SLOW TO ASTOP.
• REVERSE: GENTLY PULL THE HANDLEBARS BACK TO MOVE BACKWARDS.
• TO TURN RIGHT: GENTLY PULL THE RIGHT HANDLEBAR UPWARDS AND THE LEFT HANDLEBAR DOWNWARDS.
• TO TURN LEFT: GENTLY PULL THE LEFT HANDLEBAR UPWARDS AND THE RIGHT HANDLEBAR DOWNWARDS.

TRAX TIP:
AVOID SUDDEN OR JERKING MOVEMENTS THAT CAN PRESENT RISKS OF INJURY OR FALLING OFF,
MISSION COMPLETE

• COME TO A COMPLETE STOP AND TURN OFF YOUR HOVERBOARD BY PRESSING THE POWER BUTTON BEFORE ATTEMPTING TO STEP OUT OF THE FLYKART.

TRAX TIP:
CELEBRATE YOUR SUCCESSFUL MISSION, AND SHOW OFF YOUR BEST SPACE ROBOT DANCE TO YOUR CREW.
GOTROVX GALAXY LAWS
To ensure all Commanders of the GOTRAX GALAXY are as safe as possible, please follow all local, state, and federal laws from all planets and safety rules for your GOTRAX FLYKART.
No mission can be guaranteed safe, and you are go-karting at your own risk, so please exercise caution following all safety guidelines below and in this manual

• Always wear a helmet, knee pads, elbow pads, and gloves.
• Always check your FLYKART for damage before operating.
• Do not exceed the 220lb (1OOkg) weight Teal
• Never go-kart in icy or wet conditions.
• Never go-kart on inclines of more than 30 degrees.
• Know and follow local laws and give way to pedestrians.
• Don’t attempt tricks or go-kart on difficult terrain without proper preparation and safety precautions.
• Commanders attempt tricks at their own risk.

If at any time you feel unsafe or uncertain, immediately abort the mission and return to base. If you are in danger, please contact the appropriate emergency services.

WANT MORE TRAX TIPS TERICKS ?!
VISIT GOTRAX.COM
RIDEGOTRAX

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>