GOTRAX GXL V2 Electric Commuter Scooter User Manual
- June 4, 2024
- GoTrax
Table of Contents
- Congratulations on your purchase!
- Don’t Ride Until You Read This:
- Warning Message
- Unpack
- Get To Know Your Scooter
- Specifications
- Assemble Your Scooter
- Charge Your Scooter
- Riding Tips
- Putting Your Scooter Away/Folding
- Maintenance & Repair
- Troubleshooting
- Warranty
- RideGOTRAX
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
GXL V2 Electric Commuter Scooter
**User Manual
**
Congratulations on your purchase!
This user manual will help you assemble and operate your new electric scooter.
Be sure to read ALL OF THE INFORMATION in this manual before riding.
NOTE TO ALL RIDERS UNDER 18 YEARS OF AGE: It’s very important that you
get parental permission before riding your electric scooter. ****
Don’t Ride Until You Read This:
ALWAYS wear a helmet when riding your electric scooter.
Make sure your scooter has a full battery before taking it out to ride.
Always be aware of local road laws, and follow them.
Do not ride the scooter under the influence of drugs or alcohol.
Always respect pedestrians.
Do not ride under wet conditions. The scooter may slide from under your feet
causing injury. Wet conditions may damage the electronics and void the
warranty.
Warning Message
- Avoid water – The scooter is not waterproof. The electronics may be damaged due to water and water damage is not covered by our warranty. Riding in wet conditions is also very dangerous and may result in injury.
- Abuse – We do not cover physical damage due to negligent care and extreme riding.
- Whenever you ride the Gotrax electric scooter, you risk severe injury or even death from loss of control, collisions, and falls. Use caution and ride at your own risk.
- Do not modify the product from the manufacturer’s original design.
- Keep hands and all body parts away from moving parts while operating the scooter.
- Before riding – be sure to check the scooter over and make sure the scooter is operating correctly before each use.
- Before riding – be sure to check that the braking system is functioning properly; also be sure to check that all safety labels are in place and you understand the safety warnings.
- Before riding – be sure that any and all axle guards, chain guards, or other covers or guards supplied by the manufacturer are in place and in serviceable condition.
- Before riding – be sure to check that the tires are in good condition, inflated properly, and have sufficient tread remaining.
- The electric scooter should never be used by children under the age of 13.
- . Maximum Speed – Your electric scooter goes a maximum speed of 15.5 mph.
- Never exceed the 220 lb maximum load rating.
Unpack
You should find each of these items in your box:
- Electric Scooter
- Console & Handlebars
- Approved Power Adapter / Charging Unit
- Allen Wrench
- Screws
- Tire Gauge Pipe
Remove all packaging material, then inspect each item for any accidental damage that may have occurred during shipping.
Get To Know Your Scooter
The electric scooter comes partially assembled.
Specifications
Top Speed:…………………………………. 15.5 mph
Distance per Charge:………………….. 9-12 miles
Weight Range Up To ………………………….220 lbs
Battery Type:……………………………………………. 36V 5.2Ah
Battery Charger DC……………………………… 42V 1.5A
Charge Time: ………………………………4 hours
Power Requirements: ……………………..AC 100 -240V— 50/60HZ
Assemble Your Scooter
Press down on the rear fender, separate the folding hook and fender buckle,
then lift the tiller upright (as shown in the figure). Once the scooter is
locked in the upright position, verify by gently trying to fold.
Use an Allen wrench to loosen the screws located at the hook and detach. Once
you’ve removed the hook and screws, make sure to remove the cover from the top
of the tiller.
Place the console on the top of the tiller.
Take the cord that is attached to the hook and bring it to the front of the
tiller. Pull the handbrake towards you and insert the round metal piece into
the opening. String the small silver cord through the solid piece of the
handbrake. Make sure the metal piece on the red cord is pushed fully into the
handbrake.
Grab
the red cord and hook and bring it back behind the tiller and reattach the
hook to the back of the tiller using the screws and an Allen wrench. ( The red
cord should go around the tiller.)
Charge Your Scooter
Before using the scooter, you must fully charge the battery.
- Open the rubber charging port cover.
- Insert the charging plug into the port.
- The charger box will have a green light when fully charged and a red light when charging.
- When you are done charging be sure to cover the charging port to keep it clear of dust and debris.
- Charging Time: 4 hours
Charging Requirement: Make sure to charge your scooter in conditions that do not exceed 104 degrees Fahrenheit or below 32 degrees Fahrenheit.
Scooter Console Functions
To power the scooter on, press and hold the red button for 1 second.
To power the scooter off, press and hold the red boon for 5 seconds.
To power, the headlight on or off, press the red boon for 1 second while the
Roofer is powered on.
The console on the scooter displays speed in MPH, battery life, and headlight.
When the scooter is powered on, press the power button 3 times to switch the
speed unit display. The default speed unit is MPH, the console will display
km/h after switching.
Riding Tips
- You will want to start riding your electric scooter with one foot on the platform and one foot on the ground. Use your foot on the ground to push off and at the same time, press the throttle button to begin movement.
- Press the handbrake to slow down or slop.
- The scooters perform best when on a smooth surface e.g. carparks, smooth roads, footpaths, and 8 bike lanes.
- Always clean your scooter (wheels, platform, etc.), it’s a machine and it needs to be maintained.
- Do not press the throttle while walking with the scooter beside you.
- Be aware of the terrain you are riding on, watch out for curbs and obstacles!
- Cruise Control: To activate the cruise control press the right-hand throttle down For 10 seconds. To deactivate the cruise control press either the right-hand throttle or brake button to deactivate the cruise control.
Putting Your Scooter Away/Folding
Before folding the scooter. make sure that the scooter is panted off. Folding:
Ensure the electronic scooter is powered off, hold the tiller and pull out the
spring pin on the right bolding panel then rotate the spring pin
counterclockwise. Insert the hook on the tiller into the loop on the rear
lender buckle. You may hear a click which indicates that you were stx«useful
in folding and locking the scooter.
Unfolding: Press the rear fender and pull the tiller up to unfold the
&envie scooter, the spring pin will insert itself in place within the folding
lever to lock the folding mechanism.
Maintenance & Repair
It you regularly dean and maintain your electric scooter, It will extend Its
life.
Cleaning and storage:
If the scooter is dirty. wipe it clean with a soft damp cloth. Brake
Adjustments 8 Serve: If you notice you need broke adjustments or any
service on your scooter, contact our customer service team and we will adjust
and repair your scooter. Do not repair your scooter yourself, this can void
your warranty and you risk damaging the scooter.
Tres: If you notice that the tire pressure is low, please fill to the
recommended PSI on the side of the tire. Recommended PSI: 50
DO NOT use alcohol, gasoline, kerosene, or other corrosive chemical solvents
to clean the scooter. It can severely damage the appearance and structure of
the scooter. Please do not use a pressure washer as it malaria cause damage to
the electronics.
Storage : When you’re not using your scooter store in a dry and cool
location. Avoid storing your scooter outdoors because sun exposure can damage
its appearance and may cause wear on the Lie of the battery and ties.
Tightening the Tiller: If you notice that the tiller is loose or wiggles
while tiding, you can tighten the screws. Open the plastic cover, and use the
Allen wrench to tighten the screws as shown in the figure below.
** Battery Information
Only use the approved Gotrax power adapter to charge your scooter, others may
cause a risk of fire & equipment may be damaged. Improper cSsposal of used
batteries may seriously pollute the environment. Nose complies with local
osposal regulations. Make sure to store your scooter and power adopter in
conditions that do not exceed 122 degrees Fahrenheit or below 4 degrees
Fahrenheit.
Warning • Risk of fire**
No User Serviceable Paris, The prolonged exposure to UV Rays, Ron and the
Elements may damage the enclosed materials, store indoors when not in use.
Troubleshooting
We frequently update our user manuals at gotrax.com , and reserve the rights to update and c hong< manuals online. Please contact our customer service team it you are experiencing problems or need more detailed Information. They can be reached at gotrax.com.
Warranty
For warranty information, please visit us of www.gotrax.com
RideGOTRAX
GOLAB’S, INC
GOTRAX.com
2201 Luna Rd.
Carrollton, TX 75006
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>