AUXBEAM H6024 7 Inch LED Headlights User Guide
- June 1, 2024
- AUXBEAM
Table of Contents
AUXBEAM H6024 7 Inch LED Headlights User Guide
Connection of wiring harness
Installation Steps (To Exemplify)
-
Turn off the engine, discon- nect the battery and carefully remove the front grille.
-
Remove the existing headlights from the bumper and keep all hardware that attaches the headlights to the vehicle.
-
Unplug the connector of the existing headlight.
NOTE: On newer models there is a red button on the plug that must be pushed up, and a green button that must be pressed and held to unplug the existing lamp.
-
Plug in the headlight H4 plugs. Tap wire to the positi- tive of DRL and turn signal light on both sides (IF ANY).
-
Test these lights to make sure they work well before you put back the hardware.
-
Install fixing screws and the existing hardware.
H4 to H13 Adapter Wiring Harness
Note: Some products may not come with this adapter cable, please refer to the description on the product page.
Lighting Effect (To Exemplify)
How to remove the moisture in the headlights?
- Remove the headlights and open the vent valve on the back cover, with the front panel facing down and the cover facing up.
- Turn on the light for half an hour to remove the moisture.
- After removing the moisture, cover the vent valve back and install it back in your car.
CAUTION
- READ ALL SAFETY MESSAGES AND UNDERSTAND ALL INSTRUCTIONS BEFORE ATTEMPTING TO INSTALL THIS PRODUCT.
- ALWAYS WEAR SAFETY GLASSES DURING INSTALL.
QUICK FEEDBACK
IF YOU MEET SOME PROBLEMS, PLEASE CONTACT OUR CUSTOMER SERVICE FOR QUICK HELP.
Method 1: 1:
Scan QR code to obtain supporting.
Method 2:
Email contact AUXBEAM Customer Service. Customer
CUSTOMER@AUXBEAM.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>