VOLLRATH T3894660 One Piece Cafeteria Breath Guard Installation Guide

Table of Contents

Specifications

One Piece Breath Guard Installation

Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown in Figure 1. Repeat for all four uprights.

Three-Piece Breath Guard Installation

Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown in Figures 1 and 2. Repeat for all four uprights.
Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C). Repeat on the other side.
Install the one-piece breath guard (E) securing with screws (F) and cap nuts (C). Repeat for all four mounting locations.
Install the side breath protector (G) to the support tube (D) securing with cap nuts (C). Repeat on the other side.
Install the support bar and stud assembly (H) to the side breath guards (E). Repeat for all mounting locations.
Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations.

Q: What should I do if I over-tighten the cap nuts?

A: Overtightening may cause the plastic to crack. Exercise caution and ensure proper tightening without excessive force.

Q: Can I use additional screws for extra support during installation?

A: It is recommended to follow the provided installation instructions to ensure proper assembly and structural integrity of the breath guard.

Q: How do I clean the breath guard?

A: Use a mild detergent solution and a soft cloth to clean the breath guard. Avoid abrasive cleaners that may damage the surface.

One Piece Cafeteria Breath Guard Three Piece Cafeteria Breath Guard

These instructions cover the installation of the one-piece Cafeteria Breath Guard and the three-piece Cafeteria Breath Guard.

One Piece Breath Guard Installation

To install the breath guard follow these steps:

NOTE: Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.

Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figure 1. Repeat for all four uprights.
Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
Install the one-piece breath guard (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all four mounting locations.
Install the side breath protector (G) to the support tube (D) securing it with cap nuts (C) as shown. Repeat on the other side.

Three-Piece Breath Guard Installation

Some units are shipped with a breath guard not installed. To install the breath guard follow these steps.
NOTE: Use caution when tightening the cap nuts. Overtightening may cause the plastic to crack.

Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figures 1 and 2. Repeat for all four uprights.
Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
Install the side breath guards (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all mounting locations.
Install the side shield (G) to the support tube (D) securing it with cap nuts (C) as shown. Repeat on the other side.
Install the support bar and stud assembly (H) to the side breath guards (E) Repeat for all mounting locations.
Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations.