ATEN VK112EU Button Keypad User Guide
- June 2, 2024
- Aten
Table of Contents
ATEN VK112EU Button Keypad User Guide
Package Contents
- 1 VK112EU 12-Button Keypad
- 1 button pack
- 1 terminal block
- 1 faceplate
- 1 user instructions
Hardware Overview
-
Buttons
The layout is customizable using 6 to 12 buttons. -
Button LEDs
- lights orange to indicate that the button is supplied with power.
- lights white to indicate that the button is in operation.
- blinks orange and white to indicate that fi rmware upgrade is in progress.
-
System LED Indicators
- LAN: lights green to indicate that the VK112EU is connected to LAN.
- Link: lights green to indicate that the VK112EU is connected to the assigned Control Box.
-
Reset Push button
Press to reset the network to default settings.
-
DC Power
Connect the power adapter into the terminal block. -
Keypad ID Switch
Sets the ID of the VK112EU.
-
Control Box ID Switch
Assigns the VK112EU to a Control Box by specifying the Control Box’s ID.
-
LAN Port
- Connects the VK112EU to LAN.
- Supplies Power over Ethernet using an Ethernet cable.
Installation
Step 1 Prepare the installation site
Install the Keypad into a chosen surface with or without a 2-gang wall box.
Refer to the cutout diagram above to prepare the installation site with the
specifi ed dimensions to accommodate the device.
Note: ATEN recommends a 2-gang wall box with a depth of at least 5 cm (1.97 inches) to accommodate the connectors and cables.
Step 2 Install the Keypad
-
Use the keypad ID switch to set an ID for the unit, and set the control box ID switch to the ID of the control box to which you wish to connect.
-
Thread the required cables to supply power and network connectivity to the Keypad. Do one of the following:
- Use an Ethernet cable to connect the Keypad to a PoE switch.
- Use an Ethernet cable to connect the Keypad to LAN and a power adapter to supply the power. For more information about installing a terminal block to the power adapter, refer to the ATEN Control System User Manual.
Note: The Keypad adopts the default IP address (192.168.0.60) if the network switch does not support DHCP. To change the IP address, log in the web interface using the default IP address with the default password (password).
-
Secure the Keypad to the wall box or the chosen surface.
-
Install the button caps and the face plate.
Configuration
Use ATEN Confi gurator to create and upload a control interface (Viewer) for the Keypad. For detailed information, see ATEN Control System User Manual.
Support and Documentation Notice
All information, documentation, fi rmware, software utilities, and specifi
cations contained in this package are subject to change without prior notifi
cation by the manufacturer.
To reduce the environmental impact of our products, ATEN documentation and
software can be found online at http://www.aten.com/download/
Technical Support
Scan for more information
Product Page
User Manual
© Copyright 2024 ATEN® International Co. Ltd.
ATEN and the ATEN logo are registered trademarks of ATEN International Co.,
Ltd.
All rights reserved. All other trademarks are the property of their respective
owners.
Part No. PAPE-1223-K61G Released: 02/2024
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>