VOLLRATH 39727W Cafeteria Breath Guard Installation Guide
- August 14, 2024
- VOLLRATH
Table of Contents
VOLLRATH 39727W Cafeteria Breath Guard
Specifications
- Product Name : Cafeteria Breath Guard
- Model : One Piece / Three Piece
- Manufacturer : Vollrath Company, L.L.C.
FAQ
- Q: What should I do if I encounter cracks in the plastic during installation?
- A: If you encounter cracks in the plastic during installation, stop tightening immediately to prevent further damage. Contact customer service for assistance and possible replacement parts.
- Q : Can I disassemble the breath guard for cleaning purposes?
- A : Yes, you can disassemble the breath guard following the reverse steps of the installation instructions. Clean each component separately and reassemble after cleaning.
Installation Instructions
These instructions cover the installation of the one-piece Cafeteria Breath
Guard and the three-piece Cafeteria Breath Guard. One Piece Breath Guard
Installation
Some units are shipped with a breath guard not installed. To install the
breath guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Overtightening may cause the
plastic to crack.
- Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figure 1. Repeat for all four uprights.
- Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
- Install the one-piece breath guard (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all four mounting locations.
- Install the side breath protector (G) to the support tube (D) securing it with cap nuts (C) as shown. Repeat on the other side.
Three-Piece Breath Guard Installation
Some units are shipped with a breath guard not installed. To install the
breath guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Overtightening may cause the plastic
to crack.
- Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figures 1 and 2. Repeat for all four uprights
- Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
- Install the side breath guards (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all mounting locations.
- Install the side shield (G) to the support tube (D) securing it with cap nuts (C) as shown. Repeat on the other side.
- Install the support bar and stud assembly (H) to the side breath guards (E). Repeat for all mounting locations.
- Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations
CONTACT
- The Vollrath Company, L.L.C.
- 1236 North 18th Street
- Sheboygan, WI 53081-3201
U.S.A.
- Main Tel: 800.628.0830
- Service Tel : 800.628.0832
- FAX : 800.752.5620
- Vollrath of Canada, Co.
- Tel: 800.695.8560
- FAX : 800.752.5620
- www.vollrathco.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>