Schier CC1 Clamping Collar Kit Installation Guide
- May 15, 2024
- SCHIER
Table of Contents
CC1 Clamping Collar Kit
Installation Guide
SPECIFICATION AND INSTALLATION GUIDE
CC1 Clamping Collar Kit for use with Grease Interceptors Models GB1, GB2 and
GB3
CC1 Clamping Collar Kit
Notes
- 12 ga. Stainless steel clamping bars
- Unit weight: 10 lbs.
Engineer Specification Guide:
Clamping Collar kit to consist of stainless steel clamping bars and stainless
steel self tapping hex head mounting screws.
GETTING TO KNOW THE CC1
- Self Tapping Hex Head Screws (x15)
- Clamping Bars (x3)
INSTALLATION
Special Precautions
Read all instructions before installation
Install in conformance with all local codes
CAUTION
The CC1 Clamping Collar Kit is designed to fasten to the FCR1 Field Cut Riser. DO NOT fasten directly to the body of the grease interceptor
-
Lay Membrane suspended installation
Lay membrane over the FCR1 riser -
Cut Membrane
** Cut a relief “+ ” pattern in the membrane directly over the opening of the FCR1 accessway. **
-
Fasten Clamping Bars Using the self tapping screws provided, fasten the (3) Clamping Bars directly to the flange of the FCR1
-
Remove Membrane from AccesswayCut and remove membrane from the accessway of the FCR1
-
Complete the Finished Grade per the “Buried Installation” Instructions for your GB1, GB2, or GB3 Grease Interceptor
CC1 Installation Guide
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>