SUN GLOW Roller Shade Curved Cassette & Compact Curved Cassette Installation Guide
- May 15, 2024
- SUN GLOW
Table of Contents
SUN GLOW Roller Shade Curved Cassette & Compact Curved Cassette
Product Information
Specifications
- Product Name: Roller Shade – Curved Cassette & CompactCurved Cassette
- Components: A. Shade, B. Mounting Brackets, C. Safety Shield
- Roll Options: Regular Roll, Reverse Roll
- Warning: Strangulation Hazard – Cord length should not exceed 22 cm or loop 44 cm
Product Usage Instructions
Preparation
Before starting the installation process, ensure you have all the
components from the component list B, including the shade, mounting brackets,
and safety shield.
Determine Number of Brackets
Refer to the Shade Width and the corresponding number of brackets needed
for installation.
Installation Process
Follow these steps for installing the Roller Shade:
- Choose between regular roll or reverse roll configuration based on your preference.
- Mount the brackets securely on the surface where you plan to install the shade.
- Attach the shade to the mounting brackets ensuring it is securely in place.
- Install the safety shield to prevent any strangulation hazards, especially if young children are around.
FAQ
-
Q: Can the Roller Shade be easily adjusted for different window sizes?
A: Yes, the Roller Shade can be adjusted to fit various window widths by following the installation instructions and using the appropriate number of brackets. -
Q: Is it possible to customize the fabric of the Roller Shade?
A: Some models may offer customization options for fabric choices. Please refer to the product specifications or contact customer service for more information.
Installation Instructions
WARNING
STRANGULATION HAZARD — Young children can be strangled by cords.
Immediately remove this product if a cord longer than 22 cm or a loop
exceeding 44 cm around becomes accessible.
PREPARATION
Component List
- A. Shade
- B. Mounting Brackets
- C. Safety Shield
Note :The Square Cassette can be configured in either reverse roll or regular roll. The installation process is identical regardless of this configuration.
DETERMINE NUMBER OF BRACKETS
- Determine the proper position for each bracket. The outside brackets should be no further than 2” from the ends of the cassette.
- The brackets should be securely mounted and equally spaced for the width of the shade.
- It is important that the mounting brackets be installed level and aligned to each other. Shimming may be required.
MOUNT THE BRACKETS
-
CEILING MOUNT
For ceiling mount applications, please ensure that you leave a ¼” between the wall and the mounting bracket to facilitate mounting and dismounting. -
WALL MOUNT
For wall mount applications, please ensure that you leave a ¼” between the ceiling and the mounting bracket to facilitate mounting and dismounting.
INSTALL THE SHADE
- With the front face of the cassette facing you, (1) insert the back edge of the cassette onto the bottom of each mounting bracket, as shown below.
- (2) Starting from the center of the shade, push the cassette back and up until the cassette snaps into the top tab of the mounting bracket.
- (3) You should hear an audible click as the cassette snaps in to the mounting brackets. Repeat this process for each bracket.
INSTALL THE SAFETY SHIELD
NOTE : For shades with chain operation only.
Ensure that Safety Shield is carefully and properly installed.
- The loop holder and joint piece must be affixed to a wall or window frame.
- Gently pull the loop holder taut and affix with a screw, then ensure that the chain shroud is raised before installing the joint piece with another screw.
References
- DWG.BY
- Window Shading Solutions and Custom Wallpaper | Sun Glow
- Window Shading Solutions and Custom Wallpaper | Sun Glow