SUN GLOW Roller Shade Savalan Window Decor Instruction Manual
- June 4, 2024
- SUN GLOW
Table of Contents
Roller Shade – Open Roll
Installation Instructions
WARNING
STRANGULATION HAZARD — Young children can be strangled by cords.
Immediately remove this product if a cord longer than 22 cm or a loop
exceeding 44 cm around becomes accessible.
PREPARATION
Component List
A. Shade
B. Universal Mounting Bracket
C. Bracket Cover (Optional)
D. Chain Tension Device
MOUNT THE BRACKETS
Brackets are universal and are capable of receiving both the clutch and pin end.
INSTALL THE SHADE
NOTE: For shades with Zero Gravity, please refer to Zero Gravity instructions on page 3 at this stage.
STEP 3A:
INSTALL PIN END FIRST
Put the spring-loaded Pin End into the hole in the bracket.
STEP 3B:
INSTALL CLUTCH END
Keeping gentle pressure against the Pin End lift the clutch up and align the
two hooks on the clutch with the two slots in the bracket. The hooks should
fall into place in the bracket, pull down gently to secure the blind into the
bracket.
**The bottom of the Clutch should point straight down.
INSTALL BRACKET COVERS (OPTIONAL)
If you were supplied with bracket covers, install them by sliding them onto the mounting brackets.
INSTALL THE SAFETY SHIELD
NOTE: For shades with chain operation only.
Ensure that Safety Shield is carefully and properly installed.
Zero Gravity – Fascia or Open Roll Instructions
These steps are not required for Zero Gravity in Curved Cassettes. Skip
these steps if using chain, Neo, or motorized control
If the Pin End of the shade appears as shown here, proceed with Steps 1,2 & 3 before returning to Step 4 of the Open Roll Installation Instructions
If the Pin End of the shade appears as shown here, proceed with Steps 4,5 & 6 before returning to Step 4 of the Open Roll Installation Instructions
PREPARING FOR INSTALLATION
NOTE: The blue shipping lock is used to lock the tension in place during shipping.
INSTALLING THE SYSTEM
(A) Insert the pin end of the blind into the bracket.
(B) Insert the hooked end into the other side bracket, and ensure the Zero
Gravity head sits on the hooked teeth firmly. This should compress the hex
plunger which releases the tension onto the shade.
TESTING THE SYSTEM
Always operate the shade from the center of the bottom bar. Ensure that the
shade is balanced and does not want to roll up or down on its own. If it does,
then the spring will require more or less tension to be perfectly balanced. If
the shade requires more tension, turn the zero gravity head into the fabric,
ie the opposite direction to the fall of the fabric.
WARNING
- Do not pull pin lockout until the shade is installed or tension will be released.
- If tension has been released, see troubleshooting.
RUBBER BAND REMOVAL
Before installing the shade remove the rubber band holding the Pin Lock in
place.
INSTALL SHADE AND REMOVE PIN LOCK
C: Install roller shade while keeping Pin Lock toward you and held in place.
D: After installation remove the pin lock
TESTING THE INSTALLED ROLLER SHADE
The installed roller shade must be operated smoothly by the center of the bottom bar to avoid excessive telescoping
TROUBLESHOOTING:
ONLY REQUIRED IF TENSION IS RELEASED
If the tension is released or removed accidentally follow these instructions:
The tension can be put back in any Zero Gravity Mini by turning the clutch
head in the opposite direction of the fabric for approximately 1 – 2 full
rotations. While holding tension, insert the Pin Lock into the hole of the
clutch. PROCEED WITH STEP 2 WHEN FINISHED.
Installation Instructions | Open Roll | 202-04-29www.mysunglow.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>