SUN GLOW Curved Cassette and Compact Curved Cassette Roller Shade System Installation Guide
- June 12, 2024
- SUN GLOW
Table of Contents
SUN GLOW Curved Cassette and Compact Curved Cassette Roller Shade System
Product Information: Roller Shade – Curved Cassette & Compact Curved
Cassette
The Roller Shade – Curved Cassette & Compact Curved Cassette is a window treatment product designed to provide privacy and control the amount of light entering a room. It features a curved cassette design that enhances the aesthetic appeal of the shade. The shade is operated manually, either by pulling on a cord or using a chain, depending on the model.
It is important to note that this product poses a strangulation hazard to young children. Any cord longer than 22 cm or a loop exceeding 44 cm around should not be accessible to children. If such a cord or loop becomes accessible, the product should be immediately removed to prevent accidents.
Product Usage Instructions
-
Bracket Position: The VisionTM roller shade comes fully assembled and tested. It is not recommended to disassemble the shade for any reason, as doing so will void the warranty. Shimming may be required during installation.
- Each Vision™ Roller Shade System comes standard with two mounting brackets.
- It is important that the brackets be securely mounted, level, and aligned to each other. Shimming may be required.
-
Install Mounting Brackets: Attach the Flex Mounting Brackets using two #8×1.5 Pan Head Zinc Screws included in the package or equivalent screws based on the surface type. Ensure all screws are securely fastened to a sturdy structure. If installing the shade on an outside wall, a spacer plate might be required. There are different mounting options available, including Ceiling Mount, V84 STANDARD & V102 STANDARD Wall Mount, and Lateral Mount.
V84 STANDARD & V102 STANDARD
V84 FLEX
-
Install VisionTM Roller Shade System: With the Front Fascia facing you, insert the front edge of the Assembly Bracket onto the front lip of each Flex Mounting Bracket. Push upward and back until the back edge of the Assembly Bracket snaps into the bottom tab of the Flex Mounting Bracket. Repeat this process for each bracket.
-
Leveling the Shade: To adjust the shade level if the window is not square, locate the small Adjustment Screw on the Adjustable End Bracket. Use a #0 Robertson or Small Flat Head screwdriver to turn the screw clockwise to raise the shade or counterclockwise to lower the shade until it is level.
-
Install the Safety Shield: Note that this step applies only to shades with chain operation. Ensure that the Safety Shield is carefully and properly installed to ensure safe usage of the shade.
WARNING STRANGULATION HAZARD — Young children can be strangled by cords. Immediately remove this product if a cord longer than 22 cm or a loop exceeding 44 cm around becomes accessible.