Installation Instructions for your new
RAK40

Anti recirculation deflectors for Zoneline

RAK40 Zoneline Anti Recirculation Deflector

Before you begin – Read these instructions completely and carefully.
IMPORTANT — OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Note to Installer —- Be sure to leave these instructions with the Consumer.
Note to Consumer — Keep these instructions with your Owner’s Manual for future reference.

TOOLS NEEDED

• 5/16” nut driver
• 1/4” nut driver

PARTS INCLUDED IN KIT

• Deflector (2)

• 8 x/8” sheet metal screws (4)

• 8 x 3 1/2” self tapping screws (2)

STEP 1A
On models with straight outdoor coils, mount grills as shown in Figure 1 ensuring the foam gasket is facing away from the chassis. Install two (2) #8 x 3/8” screws per grill to secure.

CAUTION

• Do not use screws longer than 3/8” when mounting deflector to metal end brackets. Doing so may damage heat exchanger.
• Only use this Kit when not using a GE Appliances grill. If existing grill has air deflector attached, remove the deflector before mounting grill.

STEP 1B

• On models with “L” shaped outdoor coils, mount left hand grill as shown in Figure 1 ensuring the foam gasket is facing away from the chassis. Install two (2) #8 x 3/8” screws on sheet metal end of coil (left side when looking at the back on unit).
• Mount right hand grill as shown in Figure 2 ensuring the foam gasket is facing away from the chassis. Install two (2) #8 x 1/2” self taping screws in plastic shroud (right side of unit when looking at the back on unit) to secure.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>