eurowise 12V VR6 Intake Installation Guide
- May 15, 2024
- eurowise
Table of Contents
eurowise 12V VR6 Intake
Product Information
Eurowise 12V VR6 Intake
The Eurowise 12V VR6 Intake is designed to improve airflow and performance in your vehicle. It replaces the factory air box and intake pipe, providing a more direct and efficient path for air to reach the engine.
Specifications:
- Material : Aluminum intake pipe, silicone elbow
- Includes : Silicone elbow, t-bolt clamps, K&N air filter
- Compatibility : 12V VR6 engines
Product Usage Instructions
Step 1: Remove Factory Air Box
Remove the factory air box and intake pipe connecting the box to the throttle body. Disconnect the Mass Air Flow sensor connector before removing it from the vehicle.
Step 2: Install Silicone Elbow
Install the 90-degree silicone elbow onto the throttle body. Secure the elbow using the supplied t-bolt clamp. Do not tighten the clamp completely at this stage.
Step 3: Install Mass Air Flow Sensor
Install the Mass Air Flow sensor into the aluminum intake pipe and secure it with the supplied hardware. Ensure a flush and tight seal by pressing the sensor into the pipe with no gap.
Step 4: Insert Aluminum Pipe
Insert the aluminum pipe into the silicone elbow and secure it with a t-bolt clamp. Do not tighten completely for ease of adjustments later.
Step 5: Secure Intake Pipe
Remove the upper belt tensioner bolt (13mm) to secure the intake pipe. Reuse the upper tensioner bolt for this purpose.
Step 6: Install Air Filter
Install the supplied K&N air filter using the provided t-bolt clamp.
Step 7: Final Step
Secure all t-bolt clamps once the kit is in place with the filter installed.
FAQ
- Q: What should I do if I have questions or concerns about the product?
- A: If you have any questions, comments, or concerns related to your product, please contact us at 704-559-8100 or email us at [email protected].
INSTALLATION INSTRUCTIONS
Step 1:
Remove the factory air box completely, including the intake pipe connecting the box to the throttle body.
Disconnect the Mass Air Flow sensor connector before removing it from the vehicle.
Step 2:
Install a 90-degree silicone elbow onto the throttle body. Secure the elbow using the supplied T-bolt clamp. Do not tighten the clamp all the way until the whole intake is in place, this will make the rest of the installation easier due to some adjustments that may be needed when installing the intake pipe.
Step 3:
Install the Mass Air Flow sensor into the aluminum intake pipe and secure it with the supplied hardware.
Be sure to press sensor into pipe with no gap for a flush, tight seal.
Connect the Mass Air Flow sensor plug.
Step 4:
Insert the aluminum pipe into the silicone elbow. Secure using a t-bolt clamp, again not tightening completely for later ease of adjustments.
Step 5:
Remove the upper belt tensioner bolt (13mm) to secure the intake pipe.
Secure intake pipe while reusing upper tensioner bolt.
Step 6:
Install supplied K&N air filter using supplied t-bolt clamp.
Step 7: (Final Step)
Secure all t-bolt clamps once kit is in place with the filter installed.
IF YOU HAVE ANY QUESTIONS, COMMENTS, OR CONCERNS RELATED TO YOUR PRODUCT
PLEASE CONTACT US!
440 SPRINGBROOK ROAD. CHARLOTTE, NC 28217
References
- Specializing in European Service, Performance and Fabrication – Eurowise Performance
- Eurowise Audi, BMW, Volkswagen, Mercedes, & Porsche Service